经销商培训润滑油基础知识.pptVIP

* éá μ? 2a ? ò2 óD ?ó 2? ￡? 2 ?è ￡? è? ?? í? ò? 2? í? è? ?? ￡? 5 ?è * * ?? ì? á ?ˉ ê μ? è á| ￡o ?3 ?í ?μ êy * * * * * 针入度为25C, 0.1mm * * ?? ò? ?? êμ ?é ó? êμ ?ê D? ?ü μ? ?à 1? D? 2? í? * 47 * * * * * A number of bench tests have been developed to assess the lubricating properties of lubs/greases under boundary conditions. These tests aim to establish the maximum load the lubricant will carry In the Four Ball Extreme Pressure Test (ASTM D 2596), three steel balls are clamped together to form a cradle on which a fourth ball rotates at a known speed, under a specified load. The lub/grease under test lubricates the balls A series of 10-second runs are made at increasingly higher loads until welding on the four ball occurs. A new set of balls is used for each run At the end of each run, the average scar diameter on the lower balls is measured to establish a load -wear index The load at which welding occurs is reported as the weld point Note: IP and ASTM methods are different * 300 mL oil stried with 30 ml water ( or sea water ) at 60 C with a steel plate , is customary to run for 24 hrs, observed for rust or degree of that . * * * * Presentation explaining Technical Features , Advantages and Benefits of the Product NEXT GENERATION SHELL TELLUS OIL. Throughout this presentation the product should be referred to as Shell Tellus Oil. A hydraulic system may be perfect with respect to design and construction, but if the fluid that is used is either initially unsuitable or is in an improper condition, the operation of the equipment will be unsatisfactory, and damage to the unit may result. Selecting the proper fluid and then maintaining the fluid in good condition are just as important to the smooth, efficient operation of a hydraulic system as the choice of the equipment itself. The importance of the selection and maintenance of the fluid was demonstrated by the results of a survey conducted for the purpose of classifying the various causes of operating difficul