连铸坯形对汽车用齿轮钢热处理变形的影响.pdfVIP

连铸坯形对汽车用齿轮钢热处理变形的影响 1,2,3 2,3 2,3 1 丁 毅 覃 明 安金敏 徐 洲 （1．上海交通大学材料科学与工程学院，上海 200240 ；2 ．宝钢股份有限公司研究院特钢技术 中心，上海 200940 ；3 ．宝钢汽车汽车用钢开发与应用技术国家重点实验室，上海 201900 ） 摘 要 本文研究了连铸坯形齿轮钢热处理变形的影响。结果表明，正方形连铸坯形生产的齿轮钢热处理变形均匀， 长方形连铸坯形生产的齿轮钢热处理变形具有明显的方向性。根据实验测试结果，长方形连铸坯形生产的齿轮钢棒 材心部偏析区的成分偏析不明显，但具有明显的密度差别，因此偏析区的组织疏松可能是导致偏析区对齿轮钢热处 理变形影响的主要原因。1 关键词 齿轮钢 连铸坯形 偏析区 热处理变形 Influence of Sectional Shape of Molds for Continuous Casting on the Heat Treatment Distortion of an Automotive Gear Steel Ding Yi1,2,3 Qin Ming 2,3 An Jinmin 2,3 Xu Zhou 1 (1. School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai, 200240; 2. Special Steel R D Center, Research Institute (R D Center), Baoshan iron steel Co., Ltd., Shanghai, 200940; 3. State Key Lab of Development and Application Technology of Automotive Steels, Baoshan iron steel Co., Ltd., Shanghai, 201900) Abstract The influence of the continuous casting mold on the heat treatment distortion of a gear steel is investigate in this paper. The distortion in the gear steel produced by continuous casting mold with the square shape is uniform, while the other one in the gear steel produced by continuous casting mold with the rectangular shape is anisotropic. The element segregation of the center segregation area is not obvious in the rod steel produced by rectangular CC mold. However, the marked difference in density is measured in the cross section of the rod steel. It is suggested that the center porosity would have strong impact of the segregation on the heat treatment distortion in gear steel. Key words gear steel, continuous casting mold shape, segregation, heat treatment distortion 1