毕业设计论文--基于SPCE061A的出气宝宝系统设计与实现.doc

本科毕业设计（论文） 基于SPCE061A的出气宝宝系统设计与实现 孙大海 摘 要 现代快节奏的生活和工作中，人们往往承受着巨大的压力。本设计拟采用SPCE061A开发板控制加速度传感器实现一个“出气宝宝”系统，在人们发泄情绪打击“出气宝宝”的时候，根据打击力度发出对应的“哭声”。这样，人们以娱乐的方式合理表达了攻击性实现了心理调节。 整个系统主要由SPCE061A开发板与加速度传感器两大模块来实现。外部的“击打”会使传感器输出模拟电压信号。61板通过I/O接口读入信号，经过A/D转换和程序处理，提取出能表征外部运动程度的量，并以此控制音频函数中的音量指数，改变扬声器的“哭声”大小。 系统设计的内容大致可非为硬件设计与软件设计两部分。硬件设计主要包括外围电路的设计与连接，对I/O接口、A/D转换、音频输出的数据单元控制。软件设计主要包括自动声音播放函数、声音文件的压缩与连接、I/O接口与A/D转换的设置、主程序函数的编写等。 经过整个系统连接调试，摇动传感器，扬声器发出“哭声”，且音量大小与运动剧烈程度正相关，系统的基本功能实现。 关键词　SPCE061A；加速度传感器；I/O接口；A/D转换；音频 燕山大学本科生毕业设计（论文） PAGE 2 Abstract With the fast pace of modern life and work, people are often under huge pressure.This design uses SPCE061A development board to control acceleration sensor to realize a venting baby system. When the emotional outburst people strike venting baby, the system could give out corresponding cries according to the degree of blow. So, people express their aggressiveness in reasonable way to realize psychological adjustment. The system mainly consists of SPCE061A development board module and acceleration sensor module. External strike will make sensor output analog signal. 61 board reads signals through the I/O interface, and extracts a value which can characterize the amount of movement level outside after A/D conversion and process. Then the value could control the volume index of audio function to change the sound size of the cries. The design of the System can roughly content of hardware design and software design. The hardware design includes outer circuit design and connection.We shoud also understand the performance of I/O port, A/D conversion and audio output. Software design includes automatic sound function, sound files compressed and connection, I/O interface and A/D conversion, main program function, etc. Through the entire system commissioning, shaking sensors, speaker gives out cries, and the volumeare positively related to the intensity of movement. Then we realize the basic function of the system. Keywords　 SPCE061A；accelerati