中山大学信号与系统课件奥本海姆英文版课后答案chapter6.docVIP

Chapter 6 Answers 6.6 (b) the impulse response h1[n] is as shown in figure s6.6,as was increase ,it is clear that the significant central lobe of h1[n] becomes more concentrated around the origin. consequently. h[n]=h1[n](-1)^n also becomes more concentrated about the origin. 6.7 the frequency response magnitude |H(jw)| is as shown in figure s6.7.the frequency response of the bandpass filter G(jw) will be given by This is as shown in figure s6.7 -6000 -4000 -2000 0 2000 4000 6000 Figure S6.7 from the figure ,it is obvious that the passband edges are at 2000∏rad/sec and 6000∏rad/sec. this translates to 1000HZ and 3000Hz,respectively. (b)from the figure ,it is obvious that the stopband edges are at 1600∏ rad/sec.this translates to 800Hz and 3200 Hz, respectively. 6.8 taking the Fourier transform of both sides of the first difference equation and simplifying, we obtain the frequency response H(e^jw)of the first filter. Taking the Fourier transform of both sides of the second difference equation and simplifying ,we obtain the frequency response H1(e^jw) of the second filter. This may also be written as Therefore .the frequency response of the second filter is obtained bu shifting the frequency response of the first filter by ∏.although the first fitter has its passband between-wp and wp. Therefore, the second filter will have its passband between ∏-wp and ∏+wp. 6.9 taking the Fourier transform of the given differential equation and simplifying .we obtain the frequency of the LTI system to be Taking the inverse Fourier transform, we obtain the impulse response to be Using the result derived in section 6.5.1,we have the step response of the system The final value of the step response is We also have Substituting s(t0)=(2/5)[1-1/e^2],in the above equation ,we obtain t0=2/5 sec we may rewrite H1(jw)to be