Fe－6.5%Si轧制板材热处理制度工艺的优化.pdfVIP

49 11 Vol.49 No.11 2013 11 1445—1451 ACTA METALLURGICA SINICA Nov. 2013 pp.1445–1451 Fe–6.5%Si ℄ ∗ (, 100083) Fe–6.5%Si () . , , 300 (9.09%) 1 , , . , 850 1 min , Fe–6.5%Si , , , , , . Fe–6.5%Si , , , TG161 A 0412−1961(2013)11−1445−07 OPTIMIZATION OF HEAT TREATMENT PROCESS OF Fe–6.5%Si SHEET ZHANG Hao, LI Hui, YANG Kun, LIANG Yongfeng, YE Feng State Key Laboratory for Advanced Metals and Materials, University of Science and Technology Beijing, Beijing 100083 Correspondent: YE Feng, professor, Tel: (010 E-mail: yefeng@skl.ustb.edu.cn Supported by National Basic Research Program of China (No.2011CB606304–2) Manuscript received 2013–08–26, in revised form 2013–09–11 ABSTRACT Fe–6.5%Si (mass fraction) alloy exhibits excellent soft magnetic properties and there- fore is very suitable to be used as iron core in high frequency electromotor. However, the room– temperature embrittlement and poor workability limit the practical applications of the alloy and it is hard to be fabricated to thin sheet. It is reported that ultra–thin sheet with 0.05 mm in thickness has been successfully obtained by an advanced technique of stepwise ductilization, including hot, warm and cold rolling processes with intermediate heat treatment. And suitable heat treatment can improve the ductility of this alloy sheet, therefore it plays an important role in this technique. However, the existing heat treatment is time consuming and not suitable for industry. In this work, effects of heat treatment on mechanical properties of the hot–rolled sheet have been investigated in dependence of annealing temperature and time. The experimental results show that