JT-8001断路器动特性分析仪.docVIP

GKC高压开关动特性测试仪 使 用 手 册 武汉科新电力设备有限公司 感谢您选用武汉科新电力设备有限公司的产品，请在仪器首次使用前，详细阅读说明书。因产品不断改进，设计及规格如有变更恕不另行通知。 目 录 一、技术参数·····················································1 二、性能特点·····················································1 三、术语定义·····················································2 四、面板布置·····················································3 五、菜单操作说明·················································4 5.1 主菜单设置···············································4 5.2主菜单测试················································5 5.3主菜单查看················································6 5.4主菜单文件················································7 5.5主菜单帮助················································8 六、现场接线·····················································8 6.1地线与断口线··············································8 6.2分合闸控制线··············································8 七、传感器安装方法···············································8 7.1通用传感器················································8 7.2旋转传感器················································9 7.3直线传感器················································9 八、仪器的配套性与售后服务·······································9 九、附录一：测试所得的部份图形和文本结果·························10 十、附录二：内部电源控制接线图····································11 十一、附录三：断口接线图··········································12 十二、附录四：仪器常见技术问题····································14阅读提示：在本说明书上,软件界面上的菜单或选项用【】括起来,比如【文件】→【保存数据】表示依次选择菜单上的【文件】、【保存数据】；表示按面板上的按键。 产品技术参数 使用环境 输入电源 220V±10% 50Hz±10% 大气压力 86～106kpa 温 度 －10～40℃ 湿 度 ≦80%RH 安全性能 绝缘电阻 ＞2MΩ 介电强度 电源对机壳工频1.5KV耐压1分钟，无闪络与飞弧。 基本参数 时 间： 量程 4000.0ms 分辩率0.1ms 　　　 　误差 ①100ms以内 0.1ms±1个字 ②100ms以上 0.1%±1个字 　　　　 　　 ③同期 速　 度： 量程　20.00m/s 分辩率0.01m/s 误差　①0-2m/s以内 ±0.1m/s±1个字 ②100ms以上 ±0.2m/s±1个字 量 程 分辩率 误 差 真空断路器 50.0mm 0.1mm 1%±1个字 SF6断路器 300.0mm 1mm 少油断路器 600.0mm 行 程： 电 流： 量程 20.00A