文献翻译—PLC机型和容量的选择步骤与原则.docVIP

英文文献 PLC model and capacity of the choice of the steps and principles With the development of PLC technology, PLC product range is also increasing. Different models of PLC, its structure, performance, capacity, instruction set, programming methods, and prices also vary for each of the occasions focus. Therefore, a reasonable selection of PLC, the PLC control system to improve the technical and economic indexes of great significance. PLC from the PLC of choice of the main models, the capacity, I / O modules, power modules, special function modules, communications networking capabilities to be considered and so on. PLC model selection PLC model to choose the basic principle is to meet the functional requirements and to ensure reliable, maintenance of the premise of convenience, and strive to the best price-performance ratio. Select the main consideration for the following: A a reasonable structure There are a whole PLC and two modular structure. PLC integrated in every I / O points, the average price cheaper than modular, and relatively small size, the general process for the system is more fixed in a small control system; and modular PLC functions to expand flexibility, in I / O points, input points and output points of the ratio, I / O module types, etc. Great choice and convenience of maintenance, the general in the more complex control system. B the choice of installation method PLC system is installed into a centralized, remote I / O type, as well as multiple distributed PLC networking. Drivers do not need to set up centralized remote I / O hardware, the system responds quickly and low cost; remote I / O type for large-scale system, the distribution of a wide range of devices, remote I / O can be scattered around the installation of devices at the scene, even short line, but the need for additional drives and remote I / O power supply; multiple distributed PLC networking equipment for multiple independently controlled, res