基于DSP%2bFPGA架构的数字电视PMP设计.pdfVIP

2011 Academic and Teaching Seminar on Electronic Information Sciences of Higher Vocational Education (2011SEHVE) The Design of Digital TV PMP Based on DSP + FPGA Architecture 1 1 2 Xueping LU , Shapu REN , Chunxia XU 1Shaoxing University, Shaoxing, Zhejiang, 312000 2Zhejiang Industry Polytechnic College, Shaoxing, Zhejiang, 312000 Abstract: In this paper, a design method of digital TV PMP based on CMMB + DSP + FPGA architecture was presented. The mobile TV signal was tuned and demodulated by the mobile multimedia broadcasting receiver. Then the DSP decoded the digital signal and sent serial YUV420 data to FPGA, FPGA transformed the serial data to Parallel data and interpolated and converted color. Finally SDRAM was used for frame buffer, the output RGB data was displayed on the LCD monitor by the rate of 56 HZ. The system used FPGA to process complex video data, it lowered DSP frequency utilization, increased flexibility and expansibility. Keywords: mobile TV; PMP; FPGA; SDRAM; color space; LCD 基于 DSP ＋FPGA 架构的数字电视 PMP 设计 1 1 2 卢雪萍 ，任沙浦 ，徐春霞 1 绍兴文理学院，浙江绍兴，312000 2 浙江工业职业技术学院，浙江绍兴，312000 摘 要：本文提出了一种基于 CMMB ＋DSP ＋FPGA 架构的数字电视PMP 设计方法，由移动多媒体 广播接收子系统实现移动电视信号的调谐、解调，输出数字信号送给DSP 解码，DSP 直接将YUV420 格式信号串行输出给FPGA ，FPGA 将YUV 数据串转并，插值放大，色度转换，并采用SDRAM 作为 视频数据帧缓存，输出RGB 数据以帧频56HZ 显示于LCD 显示器。该系统采用FPGA 完成复杂的视 频数据处理工作，降低了DSP 主频使用率，增加了系统的灵活性和可扩展性。 关键词：移动电视；便携式多媒体播放器；FPGA；SDRAM；色度空间；LCD 1 引言 分辨率为 320X240,如果要满足清晰流畅的播放要求， 帧频按照 60HZ 来计算，那么