长列高强螺栓接头传力特性的有限元数值模拟.pdfVIP

第32 卷第6 期 土木建筑与环境工程 Vol.32 No.6 2010 年12 月 Journal of Civil, Architectural Environmental Engineering Dec.2010 长列高强螺栓接头传力特性的有限元数值模拟 张石波,王荣辉,黄永辉,刘小刚 (华南理工大学土木与交通学院,广州 510640) 摘　要:为研究摩擦型高强螺栓连接接头的传力特性与应力状态,采用通用有限元软件ANSYS 建 立三维有限元实体模型,对东江大桥中14 个不同的螺栓连接接头进行了细致的有限元数值模拟分 析。重点研究了长列螺栓群各排螺栓传力比、栓孔应力集中系数,高强螺栓的应力状态以及孔前传 力系数等参数的变化规律, 明确提出了各参数的取值范围, 可为该类型节点的设计验算提供参考。 关键词:摩擦型高强螺栓;传力特性;传力比;应力集中系数;孔前传力系数 中图分类号:TU391　　文献标志码:A 　　文章编号:1674-4764(2010)06-0074-05 Finite Element Analysis of Mechanical Behavior of High Strength Bolt 库 Friction Grip Long Joint 例 ZHANG Shi -bo, WANG Rong-hui , HUANG Yong-hui , LIU Xiao-gang (School of Civil Engineering and Transportation , South China University of Technology , Guangzhou 510640, P.R.China) 案 Abstract:In order to study the mechanical behavior and stress state of the high strength bolt friction grip E long joint, fourteen different bolted connections are studied with the three-dimensional finite element A analysis which is based on the general FE software ANSYS.The force-delivering ratio of each bolt, the C stress concentration at the edge of the bolt hole, the stress state of the high strength bolt and the force- delivering coefficient before the bolt hole are specially studied.Also, the ranges of these parameters value 模 are presented clearly .The results presented would be useful as references to these type joint s design and computation. 凯 Key words:high strength bolt friction grip;mechanical behavior;force-delivering ratio; stress