机械毕业设计（论文）-木材刀具切削试验台增速机构设计【全套图纸】.doc

南京林业大学 本科毕业设计（论文） 题 目： 木材刀具切削 试验台增速机构设计 学 院： 南方学院 专 业： 机械设计制造及其自动化 学 号： n090301126 学生姓名： 指导教师： 职 称： 教授 摘要关键词：　传感器????试验台????切削 全套图纸，加153893706 Abstract This paper was designed a kind of experiment table can be used for simultaneous measurement of the sensor to force three, and it can evaluation fire-fighting better, electricity chain saws chain saws the cutting performance, i.e., detecting the sharp sex, chain saws into the lighter materials, saw chain operation of the stability and saw cutting efficiency. In order to further improve the measurement accuracy of the sensor is adopted in this paper, a kind of at the same time use the eight anise ring measurement sensor, and the sensor of the direction of the force measurement high sensitivity, cross sensitivity small. First the ontology to carry on the design, determine its eight ear type anise ring structure, next to other parts design to meet the mechanical design requirements, in the final analysis, research patch position to be measured direction sensitivity, nonlinearity influence, and the measured direction across the influence of sensitivity. This design of four scheme, where each earrings on in a strain gauge set bridge, the same level or take the strain on the vertical line set of bridge, take the strain gauge on the diagonal earrings set bridge, all take the strain gauge set bridge. To contact the production practice, considering the change must be loaded points, finally choosing all take all of the strain gauge earrings set bridge. Keyword： sensorcutting force 目录 1 绪论 5 1.1 引言 5 1.2 木材刀具切削试验台国内外研究概况 5 1.2.1 国内研究概况 5 1.2.2 国外研究概况 6 1.3 本文设计工作要求 7 2 增速机构的整体设计 8 2.1 增速机构整体方案的设计 8 2.2 电动机的类型选择 8 2.3 增速机构输入和输出连接装置的选择 9 3 增速机构的设计 10 3.1带传动的设计 11 3.1.1 带传动的优点 11 3.1.2 带的选型 11 3.1.3 试验台带轮的工作情况 11 3.1.4 带的工作参数 11 3.1.5 带的计算设计 12 3.1.6 带的张紧 15 3.2 齿轮级设计 16 3.2.1 传动方式选择 16 3.2.2 齿轮工作参数 16 3.2.3 齿轮计算设计 1