齿轮箱 零件工艺卡.xlsVIP

Zeitstudie Nr. (mm) m/min mm/rev 序号 描述/Description App 机床厂家： 机床型号： 工艺师： 毛坯状态： 零件号： 工序名称 加工内容 加工简图 检具名称 夹具名称： 刀号 日期： 共 页 第 材料: 刀具直径 刀具名称 刀具编号 刀号 刀具长度 切削速度 每齿进给 切削 深度 切削 宽度 零件加工工艺卡 划线 铣面：尺寸20mm加工至21mm Φ62孔中心线Φ30孔中心线Φ35孔中心线 铣止口：120加工至119，深3 铣孔：Φ62至Φ61 钻孔：Φ13至Φ12 粗加工安装面（粗基准底面） 粗加工顶面（密封槽面） 粗加工右面（Φ35孔面） 铣面：尺寸108mm加工至109mm 铣面：距中心孔尺寸64mm加工至64.5mm 钻孔：Φ30至Φ29.5 镗孔：Φ35至Φ34.5 粗加工左面（Φ30孔面） 加工安装面（精基准底面） 铣面：加工至尺寸20±0.5mm 铣止口：Φ119.9深3.5 镗止口：Φ120深3.4 镗孔：螺纹底孔Φ63深24 镗孔：Φ62深40 铣槽：Φ66宽4距安装面尺寸24 铣螺纹：M65×2 倒角：销孔、螺纹孔、止口 精加工顶面（密封槽面） 铣面：尺寸108 铣环形槽：槽宽4.2 铰孔：Φ13 钻螺纹底孔：Φ5 倒角：环形槽、螺纹孔 攻螺纹：M6 精加工右面（Φ35孔面） 铣面：距中心孔尺寸64mm 镗孔：Φ35 镗孔：Φ30 钻螺纹底孔：6-Φ5 倒角：C4.7 倒角：螺纹孔 精加工左面（Φ30孔面） 钻螺纹底孔：4-Φ5 1.00 2.00 3.00 4.00 5.00 2.00 3.00 4.00 5.00 1.00 2.00 3.00 This time study is based on given information known up to above mentioned date. The cycle time is calculated with theoretical values for speeds and feeds of state-of-the-art tooling. Due to this fact a fluctuation of ±10% is possible. Any later announcement or change of process affecting factors (e.g. raw material quality, raw part characteristics, changes of the drawing, requested changes of tooling, Cm(k) evaluation etc.) can not be considered supplementary. EMCO reserves the right to make changes in tooling if essential. Only the conditions given in the time study are valid even if the contract defers from them. If any of the above conditions will be changed a new time study has to be performed by the application department at EMCO. In this case the changes have to be remarked in the new time study and the previous one will be invalid.