Designofthedoublepolarpulsepowerforplating外文翻译.docVIP

Design of the double polar pulse power for plating Yu Yadong, Ruan Xieyong and Pan Zhangxin Department of physics and electronic information Shaoxin University Shaoxin, Zhejiang Province, China yuydfriend@ Abstract –The double polar pulse digital power source was designed for plating. dsPIC30F3011 acted as MCU for producing PWM pulse in the design. M57962L was used to drive IGBT. So as to isolate controller from main loop of power by opticalcoupler, LM331 was used to process conversion of A/D. Arithmetic of PI was adopted to control output voltage and current. The tryout proved the controller has good stability and it can output double pole pulse whose frequency is adjustable from 10HZ to 10KHZ. Index Terms - double pole pulse, digital power source, PWM I. INTRODUCTION Plating power is one of key device in the field of plating industry. DC power and pulse power are two kings of power widely used at present. DC power output continuous smooth current. And the direction of current doesn’t change along with the change of time in the course of plating. Although the value of current density is big while DC power is adopted, current efficiency is low and quality of plating layer is bad. Because crystal of plating layer is small under pulse power condition, more subtle and symmetrical plating layer can be obtained[1]. And raw material can be saved, so pulse power has been developed rapidly in plating domain[2]. At present, researches on pulse power concentrate on changeable polar pulse and high power[3]. Double polar pulse power whose pulse width and frequency is adjustable winding of transformer. Voltage of secondary winding of transformer will be adjusted with the change of duty ratio of IGBT. The secondary winding of transformer is divided into two groups. One of them provides positive pulse for the load through D1 and D2. And another provides negative pulse for the load through D3 and D4. The frequency and duty ratio of the pulse are controlled by the PWM si