充填管口孔形对粘稠流体断流效果影响研究.pdfVIP

Influence of the Filling Orifice Shape on the Flow Break Effect of Viscous Fluid Fuxing Yang1,2 ，Zesheng Wang1 1.Donghua University ，Shanghai 200051；2.Shanghai ocean university, Shanghai, 201306 e-mail fxyang@shou.edu.cn Abstract: The round pore and square pore in the package measuring and filling mold were analyzed respectively. The parameter concerned with flow break effect was obtained by comparing the flows and pressure drop equations of viscous fluid in the two different pores. It was found that the parameter was determined by the exit pressure drop and the one with lower pressure drop had a better flow break effect. This research was expected to compare and design the flow break effects of pores with different shapes. meaning to the persons intresting with the development of large-scale email system. Keywords: filling ；viscous fluid ；orifice ；zero flow 充填管口孔形对粘稠流体断流效果的影响研究 1、2 1 杨福馨 ，王生泽 1. 东华大学，上海 200051 ；2. 海海洋大学,上海 201306 e-mail fxyang@shou.edu.cn 【摘要】分别对包装计量充填咀的圆孔和方孔中粘性流体流速分析与力的平衡进行比较。并 研究粘稠流体在两种孔内的流量和压力降方程。进行比较，得到影响出流时断流的效果，该 效果由出口处压力降决定。压力降小的被视为断流效果好，该研究将可对不同孔形断流效果 进行比较和设计。 【关键词】充填；粘稠流体；管口；断流 1 引言 是充填管口特性。本研究问题就是探索充填管口 最近，在粘稠流体包装计量充填中，对于计 形状对粘稠流体断流效果的影响问题。 量精度要求越来越高。特别是贵重的食品、药品 粘稠流体在充填管口内的压力分布及其变 和保健品计量精度要求很高。而影响计量精度的 化，将影响到断流。充填管口内流体的压力分布 关键在于计量充填机构的充填出流口处于的断 和变化与管口孔形有直接的关系。试验表明，用 流，影响断流的因素很多，包括孔径[1] ，充填机 不同的充填管口进行计量，充填口处产生压力降， [2] [3] 压力降小的充填管口更有利于断流。这是因为压 构挤出压力 ，流体在孔口壁处的表面张力 ，