卷管法安装海洋管中管的有限元分析.pdfVIP

第 48 卷 第 5 期 天津大学学报 (自然科学与工程技术版) Vol.48 No.5 2015 年 5 月 Journal of Tianjin University (Science and Technology) May 2015 DOI:10.11784/tdxbz201310076 卷管法安装海洋管中管的有限元分析 李 英，刘志龙，丁鹏龙，杨树耕 (天津大学水利工程仿真与安全国家重点实验室，天津 300072) 摘 要 ：针对在 1,500,m 水深以卷管法安装管中管的过程进行了数值模拟．建立了管中管横截面的平面应变有限元 模型，研究内外管之间的相互作用，将接触力和变形关 系等效为内外管之间的非线性接触属性；建立了整体有限元 模型进行管中管的安装分析，研究了内外管的受力和弹塑性 形，并研究了安装过程造成的内外管之间保温层厚度 的折减．结果表明，外管承受了主要的拉力，内外管在安装中发生两次弹塑性应力-应变循环，内管和外管产生最大 的累积塑性应变分别为 4.13%和 5.07%；安装完成后保温层最大的厚度折减为 26.2%． 关键词 ：管中管；卷管法；有限元分析；累积塑性应变；应力-应变关系 中图分类号：TE54 文献标志码 ：A 文章编号 ：0493-2137 (2015)05-0438-07 Finite Element Analysis of Subsea Pipe-in-Pipe Installation with Reel-Lay Li Ying ，Liu Zhilong ，Ding Penglong ，Yang Shugeng (State Key Laboratory of Hydraulic Engineering Simulation and Safety ，Tianjin University ，Tianjin 300072 ，China) The installation procedure with reel-lay was simulated numerically for a pipe-in-pipe (PIP)in an oil field of Abstract ： 1,500,m in water depth. The interaction between the carrier pipe and the flowline was studied by carrying out plane strain analysis of PIP cross-section. Accordingly ，the relationship between contact force and displacement was equivalent to the nonlinear contact property between the carrier pipe and the flowline. Finite element model was set up to simulate the installation procedure of PIP with reel-lay. The aims are to investigate the load effect and elastic-plastic deformation of PIP and quantify the thickness reduction of insulation layer between pipes during installation process. The results show t