深搅夹芯桩在市政工程中的应用.pdfVIP

中国土木工程学会水工业分会结构专业委员会第五届第一次会议论文集 2011 深搅夹芯桩在市政工程中的应用 杨 涛 1 魏耀红 1 杨 竞 2 （1.中国市政工程中南设计研究总院，武汉，430010 ，2.武汉建筑设计院，武汉，430010 ） [摘 要] 污水处理厂和水厂的构筑物均需考虑抗浮措施，部分埋入地下较深的构筑物自重不能满足抗浮要求 时，需考虑抗浮措施。采用桩基抗浮即是抗浮措施之一。根据工程的实际情况，本文提出了采用深搅夹芯桩 用于构筑物的抗拔和抗压，经过理论计算和工程检测，满足了设计要求。通过本文的初步研究，提出了深搅 夹芯桩的计算公式，也对其构造和施工提出建议。 [关键词] 深搅夹芯桩 抗拔桩 抗压桩 THE APPLICATION OF DEEP MIXING SANWICHED PILES IN MUNICIPLE ENGINEERING YANG Tao1 WEI Yao-hong1 Yang Jing2 (1.Central and Southern China Municipal Engineering Design Research Institute, Wuhan, 430010; 2.Wuhan Architectural Design Institute, Wuhan, 430010) Abstract: The structures in the buildings of sewage treatment plant and water works are required to consider the anti-floating measures, although some structures are deeply buried underground, they can not meet the weight requirements of anti-floating, the anti-floating measures are very important. As one of the anti-floating measures, anti-floating pile is widely used in foundation works. According to the actual project, this paper made a preliminary study of deep mixing sandwiched piles, and analysis the structural characteristics of tension and compression when the structures are used with deep mixing sandwiched piles. Contrasted the theoretical calculations with the engineering testing, this approach meets the design requirements. The Author not only proposes the formula of deep mixing sandwiched piles, but also makes recommendations for its structure and construction. Key words: Deep mixing sandwiched piles; Uplift piles; Compressive pile 0 引言 污水处理厂和水厂部分构筑物埋藏深，池体大，若遇地下水位较高，需考虑采取抗浮措施。 当构筑物自重不能满足抗浮要求时，一般考虑采用桩的抗拔来满足构筑物的抗浮要求。 昆明某污水处理厂位于昆明市海埂东侧的滇池之滨，场地下部为粘土、泥炭质土、粉砂及 粘土层，砂层顶面埋深 2～3 米，厚度为 8 米