1000MW汽轮机组水封系统改造.pdfVIP

1000MW 汽轮机组水封系统改造 1 2 2 2 樊向松 ，尹金亮 ，陈长利 ，李国新 （1. 中电投电力工程有限公司平顶山鲁阳电厂项目; 2. 中电投平顶山发电有限公司，河南省平顶山市，467000 ） Reformation of Watertight Sealing System by Steam Turbine Generator Unit 1000MW 1 2 2 2 Fan Xiangsong , Yin Jinliang , Chen Changli , Li Guoxin (1.CPI Power Engineering Co. LTD Pingdingshan Project office; 2.CPI Pingdingshan power generation Co. LTD, Pingdingshan Henan province China 467000) Absract: Through the designing analysis of steam 组凝汽器水封套管因土建预埋时偏斜严重 bleeding pipeline in 1000MW Power Plant ,and 超标，造成水封管道无法安装，同时厂房结 investigate.Influenceoof vacuum at the running status. 构紧凑，无法重新布置。设计院变更单级结 To change the single stage U style drain water piping 构型式为 U 型水封，由原-10m 标高改为 at the watertight seal system.Connect to No.7 -4.5m，即水封总高度变为 12.6m。结果运行 low-pressure heater dangerous drain water piping by 时凝汽器水封不稳定，三台真空泵运行，无 way of the drain water piping at the bottom of gland 备用状态下真空仍达不到设计要求， steam condenser , parallel connection and use with 1030MW 负荷，循环水进水温度 19℃时真空 nain watertight seal stystem. Guarantee not only the 为-94KPa 。从低压缸效率分析，核定为 86.6% condenser vacuum not to be break or exhaust, but also 低于设计值，超过合同规定的煤耗和热耗。 save the steam medium, at the same time one pipe 多次真空查漏均正常，轴封漏汽量仍大于设 system Strike Trouble,it can be use. 计值，曾决定揭开低压缸处理汽封间隙，以 达到设计要求。后就地检查发现：水封注水 Key words: low-pressure heater; watertight seal pipe; 门打开，一旦关闭水封注水门，水封管道内 condenser vacuum; drain water piping; gland steam 密封水即被抽空，φ32×2.5mm 的注水管在 condenser 0.65Mpa 除盐水压力下连续注水，在凝汽器 摘要：通过对 1000MW 机组水封系统疏水管道的设