外文翻译--存储器的工作原理.doc

The work principle of the Memory The structure of the Memory The Memory is used to deposit the data. It is to make use of high and low even electricity to deposit the data, and that is to say, its depositing data is an electricity even and high and low, not the 1234 such as arithmetic figure, then, our riddle undone. So computer is not mysterious too. A Memory looks like some small drawers, there are eight small blanks in a small drawer, every small blank is used to deposit the electric charge, the electric charge spreads to come in or release passing the electric wire that connect with each other, as to the electric charge how to place in the small blank, we need not worried. You can think the electric wire as water pipe. The electric charge in the blank is water. That is easy to comprehend. The small drawer in saving each one in the machine is a place that puts the data, we call it as a Unit. We can start depositing the data. If you want to put into a figure 12, that is we as long as save No.2 and No.3 small blank in full electric charge, but other small electric charge in the blank to release. But the problem comes out, Memory contain a lot of units, the line is to parallel. When you put the electric into a blank, you will put the electric charge into all units, and when you release the electric charge, you will put all electric charge in every unit. So how many units the Memory have, you can put the same piece, this of course is not what we hope, therefore, we need make some varieties on the construction slightly. Every unit has a control line, I want to put the data into which unit, the control line that give a signal in this unit. This control line open the switch, like this, electric charge can then flux free, and the other unit control lines have no the signal, so the switch do not open, cant suffer from the influence, like this, the control line that only control the different unit, can write in to each unit the different data. The same as, if wa