Chapter5 Cam Mechanism.pptVIP

The process(步骤) to design the pitch curve is: 1.Draw the prime circle with radius rp and offset circle with radius e.draw the initial position C0(B0) . 2.Divide the cam angle for rise and return in the displacement curve into a number of equal segment. 3.Divide the prime circle into the 4 segment :180。30。90。60。 In the direction opposite to ω.then divide the segment,get C1、C2…C9 etc. 4.Through point C1 C2 …C9,draw a line and make them all tangent to the offset circle.find B1 point on the tangent line ,make 1－1’＝B1C1 ,in the same way,points B2,B3….B9 are got. 5.The pitch curve is obtained by drawing a smooth curve through each point B. Note： 1、 The pitch curve can not be drawn in the direction of ?. 2、the centerline of the follower must always be tangent to the offset circle 5.3.2 Graphical Synthesis of Plate Cam with Translating Roller follower. The roller is always tangent to the cam contour(廓线) at all times. 第*页 Theory of Machines and Mechanisms (机械原理) Chapter1 Introduction Chapter2 Structural Analysis of Planar Mechanisms Chapter3 Kinematic Analysis of Mechanisms Chapter4 Planar Linkage Mechanisms Chapter 5 Cam Mechanisms Chapter 6 Gear Mechanisms Chapter 7 Gear Trains Chapter 8 Other Mechanisms in Common Use Chapter 9 Balancing of Machinery Chapter 10 Motion of Mechanical Systems and Its Regulation Chapter 11 Efficiency of Machine This chapter mainly introduces the characteristics and classification of cam mechanisms, Follower Motion Curves and designing the cam contour. Emphases★： characteristics, basic Knowledge(lift,pressure angle) and follower motion curves. Difficulties▲: Design the cam contour Problems and Exercises Summary and kernel 5.1 ★ Characteristics and Classification of Cam Mechanisms 5.2 ★ Follower Motion Curves 5.3 ★ ▲ Plate Cam with Translating Roller (or knife-edge) 5.4 Plate Cam with Oscillating Roller Follower 5.5 Plate Cam with Translating Flat-faced Follower 5.1Characteristics and Classification of Cam Mechanisms Linkage