板的屈曲分析.pptVIP

WS9-* NAS101, Workshop 9, February 2004 WORKSHOP 9 Buckling Analysis of Plate Workshop 9 (cont.) Model description The model dimensions are 20 inches by 8 inches. The following boundary conditions are applied to the model: Pin at the left end Rollers at the right end Zero vertical deflections at top and bottom edges Apply 100psi compressive loads at the right edge Total load at right edge = (100) (8) (.01) = 8 Apply 1 lb each at grid points 11 and 55 Apply 2 lbs each at grid points 22, 33, and 44 Workshop 9 -- Boundary Conditions Simply supported Supported on rollers Supported in the Vertical Direction Supported in the Vertical Direction Workshop 9 -- Applied Loads 2 2 2 1 1 Suggested Exercise Steps: Create geometry to model the plate. Create mesh seeds and then a surface mesh. Create material properties for steel. Create shell element properties for the plate. Apply appropriate boundary conditions based on the model description. Apply loads to the nodes on the right end of the plate to model the distributed edge load. Analyze the model with MSC.Nastran. Post-Process results using MSC.Patran. Create the first surface Geometry: Create / Surface / XYZ. Enter 20 8 0 for the Vector Coordinate List. Use [0 0 0] as the Origin Coordinate List. Click Apply. Step 1: Create Geometry c b a d Create mesh seeds that will be used to guide the mesh. Elements: Create / Mesh Seed / Uniform. Input 4 in the Number of Elements. Select Surface 1.1 as the Curve List. Click Apply. Input 10 in the Number of Elements. Select Surface 1.4 as the Curve List. Click Apply. Step 2: Create Finite Element Mesh Surface 1.1 Surface 1.4 c b a d e f g Step 2: Create Finite Element Mesh Create surface mesh based on the mesh seeds assigned in the previous steps. Elements: Create / Mesh / Surface. Select Quad as the Elem Shape. Select IsoMesh as the Mesher. Enter Surface 1 for Surface List. Click Apply. a b c d e Step 3: Create Material Create the material steel. Materials: Create