光信号放大在光纤中如何实现.ppt

本文观看结束！！！ 9.3 光纤放大器的结构——多级 Configuration of a two-stage amplifier setup, with an interstage isolator and bandpass filter. 9.3 光纤放大器的结构——双向 Basic amplifier configurations for a bidirectional transmission system using a single fiber link. In the pure bidirectional configuration (left) the same erbium doped fiber is used for signals traveling in both directions, whereas in the separate amplifier bidirectional configuration (right) the signals are separated before being traversing different erbium-doped fibers each operating in unidirectional configuration, 9.3 光纤放大器的结构——双向 Repeater configuration for a bidirectional transmission system using a common erbium-doped fiber amplifier for both upstream and downstream signals, with reflections suppressed by a mid-point arrangement of isolators and bandpass filters. Experimental demonstrations of erbium-doped fiber power amplifiers. 9.3 光纤放大器的结构 Experimental pump to signal power conversion efficiencies as a function of fiber length, for pump powers of 50 and 100 mW at 980 nm, in the copropagating (solid line) and counterpropagating (dashed line) configurations (signal input -3 dBm at 1533 nm). 9.3 光纤放大器的结构 Spectrally resolved gain as a function of signal wavelength and signal input power, for a 10 m length of fiber A pumped with 50 mW at 980 nm. 9.3 光纤放大器的结构——增益平坦 Architecture of a dual-arm gain-flattened erbium-doped fiber amplifier with more than 80 nm of bandwidth, with gain in both the 1550 nm and 1580 nm regions. 9.3 光纤放大器的结构——增益平坦 Schematic of a a possible configuration for a single-stage erbium-doped fiber preamplifier. 9.3 光纤放大器的结构 Configuration of a 2.488 Gb/s unrepeatered transmission experiment over 529 km using remotely pumped postamplifiers and preamplifiers, forward error correction and dispersion compensation. (MZ Mod.: Mach-Zehnder modulator; PRBS: pseudo-random bit generator; PM Mod,: phase modulator; DCF: dispersion-compensating fiber; BPF: band pass filter). 问题与思考题？ 1、稀土掺杂光纤的种类有哪些，其增益的峰值波长各为多少？ 2、稀