离心浇铸挤压复合钢管界面组织与性能刘建彬.pdfVIP

OI :10.13374/j.issn1001 -053x.2008.11.014 30 11 Vol.30 No.11 2008 11 Journal of University of Science and Technology Beijing Nov.2008 　 1) 1) 1) 2) 3) 刘建彬 　韩静涛 　解国良 　鲍善勤 　王黎晖 1), 100083　2), 621700 3), 056300 　　20Cr/1Cr18Ni9Ti. , ., , , 、. , , . 　;;; 　TG249.4 Interfacial microstructure and properties of clad steel pipesby centrifugal casting and extruding 1) 1) 1) 2) 3) LIUJ ianbin , HAN Jingtao , XIE Guoliang , BAO Shanqin , WAN G Lihui 1)School of Materials Science and Engineering, niversity of Science and Technology Beijing, Beijing 100083, China 2)Sichuan Great Wall Steel Pipe Co.Ltd., Jiangyou 621700, China 3)Xinxing Pipes Co.Ltd., Wuan 056300, China ABSTRACT　Clad steel pipes of 20Cr/1Cr18Ni9Ti were prepared by centrifugal casting and extruding.The interfacial microstructure of the preproduction clad steel pipes was analyzed by SEM and the mechanical properties were tested by tensile test and thermal cy- cling test.The results show that the clad steel pipes get completely metallurgical bonding interface with greatly increased bonding strength and their processability and service performance are improved due to transversal area in the interface.It is indicated that not only the centrifugal casting and extruding process can be used to produce the clad steel pipes with better microstructure and properties, but also its working procedure is simple and its production cost is low. KEY WOR S　bimetallic clad pipes;metallurgical bonding;microstructure and properties;bonding strength in interface 　　, ; [1] . ,, , ,. [2-4] ,, , . ,. ,, 20Cr/1Cr18Ni9Ti . . 1　 [5-7] . 1.1　 ,