GuideSpecification.docVIP

Guide Specification Manufacturer SimTek Fence 1330 West 400 North Orem, UT 84057 Phone: (801) 655-5236 SECTION 32 31 23 - PLASTIC FENCES AND GATES THIS SPECIFICATION SYSTEM HAS BEEN PREPARED TO ASSIST DESIGN PROFESSIONALS IN THE PREPARATION OF PROJECT OR OFFICE MASTER SPECIFICATIONS. IT FOLLOWS GUIDELINES ESTABLISHED BY THE CONSTRUCTION SPECIFICATIONS INSTITUTE, AND THEREFORE MAY BE USED WITH MOST MASTER SPECIFICATION SYSTEMS WITH MINOR EDITING. EDIT CAREFULLY TO SUIT PROJECT REQUIREMENTS. MODIFY AS NECESSARY AND DELETE ITEMS THAT ARE NOT APPLICABLE. VERIFY THAT REFERENCED SECTION NUMBERS AND TITLES ARE CORRECT (NUMBERS AND TITLES REFERENCED ARE BASED ON MASTERFORMAT, 2010 EDITION.) EDIT ENTIRE MASTER TO SUIT PROJECT REQUIREMENTS. MODIFY OR ADD ITEMS AS NECESSARY. DELETE ITEMS WHICH ARE NOT APPLICABLE. WORDS AND SENTENCES WITHIN BRACKETS [ _____ ] REFLECT A CHOICE TO BE MADE REGARDING INCLUSION OR EXCLUSION OF A PARTICULAR ITEM OR STATEMENT. THIS SECTION MAY INCLUDE PERFORMANCE, PROPRIETARY AND DESCRIPTIVE TYPE SPECIFICATIONS. EDIT TO AVOID CONFLICTING REQUIREMENTS. EDITOR NOTES ARE INCLUDED WITHIN THE TEXT OF THIS SECTION TO ASSIST THE SPECIFIER IN KNOWLEDGEABLE DECISION-MAKING. THEY SHOULD BE DELETED FROM THE FINAL TEXT. THIS GUIDE SPECIFICATION IS WRITTEN USING IMPERIAL MEASUREMENTS WITH METRIC CONVERSIONS IN PARENTHESES. THESE MAY BE SWITCHED OR ONE MAY BE DELETED TO SUIT PROJECT REQUIREMENTS. THE CONVERSION TO METRIC IS SOFT IN THE FACT THAT ROUNDING WAS UTILIZED TO THE NEAREST UNIT. SECTION 323123 - PLASTIC FENCES AND GATES Linear Low Density Polyethylene Plastic (LLDPE) Revise this Section by deleting and inserting text to meet Project-specific requirements. This Section uses the term Architect. Change this term to match that used to identify the design professional as defined in the General and Supplementary Conditions. Verify that Section titles referenced in this Section are correct for this Projects Specifications; Section titles may have changed. PART 1