SoftwareDesign.pptVIP

Kaihua Xu, Di Zhang, Yuhua Liu, Ke Xu, Yuanhao Xi ISCCCA-13 Taiyuan, China Design of Deformation Monitoring Terminal System Based on STM32  2013-4-7 Paper ID: CA248 Correspondence Email: zhd87@, xukh@ School of Computer, Central China Normal University Wuhan, China Outline Introduction Objectives The Design of Deformation Monitoring Terminal System Test Results Conclusion Introduction Review of Deformation Monitoring Reshuffled signal collection is accomplished by carrying monitoring instruments in the past GPS technology cooperated with wireless or wired transmission technology is noticed in deformation monitoring nowadays Introduction Problem Statements The transmission network was single, cannot be used once the environment is not good enough; The outdoor power was not durable enough; The suit was too expensive for wide range plant in destination areas. Wanna durable monitoring with less cost? Take UPS, multi-transmission networks into the monitoring system; Take some cheaper chips into the monitoring system Objectives Our Solutions: GPS module, GPRS module, wired transmission section and core controller based on STM32 makes up the motherboard; Scene generator with high storage battery provides the UPS; Both of the motherboard and battery are protected in stainless steel box to resist the severely outdoor condition Objectives The system used STM32 as core controller, GPIO and USART as control and communication channel. GPS, GPRS, wired transmission and power section together makes up the system motherboard. The design has been tested and been applied in geology disaster monitoring. Results show that it is adapted to the harsh environment outdoors and long term working conditions. Hardware Design Motherboard, GPS and GPRS antenna, Scene generator and packing together consist of the Terminal system. CPU based on STM32, communication module, GPS and GPRS module with specific antenna of each consist of the host. Hardware Design GPS modu