ConcreteusingthePeterFellSystem(floors,patios,paths.docVIP

Notes 1. Using this document This Document has been designed to be used in two ways: Either: a. As an appendix to the Full Spec b. As a library of clauses that can be cut and pasted into the Full Spec Peter Fell Ltd offers this document as a tool to aid the creation of a Specification. While we make all reasonable efforts to provide accurate information we accept no liability for the use of this information by the issuer. It is the responsibility of the issuer of the Specification to ensure that all provisions are correct and contain the appropriate information for the project. 2. Red Comments in Red are designed to explain the clause and should be deleted prior to issuing of the specification. 3. More Detail In depth discussion on all Specification issues to be found in The PeterFell System Technical Specifications Guide, available on line at www.peterfell.co.nz, or by calling the Peter Fell Ltd Office 09 828 6460. 4. Concrete design The PeterFell system does not affect the concrete structural design, so there is no mention of the structural requirements of the concrete. 5. Grinding Polishing Specification of ground surface must be carefully considered to ensure the correct combination of grinding depth and surface polish is achieved. This is very important so the contractor can get the correct quote.  Concrete using the PeterFell System (floors, patios, paths, drives, etc) including concrete, cutting grouting sealing The following is not a stand alone specification but comments on the specific needs of the concrete areas using the Peter Fell System – concrete colour, cutting, grouting and sealing. The clauses are to be read together with the other Specification sections on: (Comment: Add/Delete as appropriate) CONCRETE CONCRETE PLACEMENT PRECAST CONCRETE SUPPLY GROUND POLISHED CONCRETE FLOORING Where any provisions set out in the Clauses below contradict any provisions in the above Sections, or the NZ Standards such as NZS3109 3114, then provisions set