IGCT变流器吸收箝位电路的参数设计.pdfVIP

第 32 卷 第 12 期 中 国 电 机 工 程 学 报 Vol.32 No.12 Apr.25, 2012 2012 年 4 月 25 日 Proceedings of the CSEE ©2012 Chin.Soc.for Elec.Eng. 67 文章编号：0258-8013 (2012) 12-0067-08 中图分类号：TN 34 文献标志码：A 学科分类号：470·40 IGCT 变流器吸收箝位电路的参数设计 谢路耀，金新民，童亦斌 (北京交通大学电气工程学院，北京市 海淀区 100044) Design of Clamping Circuit Parameters for IGCT Converters XIE Luyao, JIN Xinmin, TONG Yibin (School of Electrical Engineering, Beijing Jiaotong University, Haidian District, Beijing 100044, China) ABSTRACT: In recent years, the power ratings of wind 部分。提出一套 IGCT 变流器吸收箝位电路的优化设计方 turbines has increased dramatically to 3~7 MW. Meanwhile, the 法，显著简化了箝位电路的设计过程。在对箝位电路换流工 requirements of the wind farm grid code are getting stricter in 况进行详细分析的基础上，提出了箝位电路的等效电路。根 harmonic control, low voltage ride through and so on. The 据等效电路进行了响应分析，综合考虑箝位电路的设计原 medium voltage full-scale converters equipped with the 则，找到了优化参数的选取方法，从而降低了最小脉宽限制， integrated gate commutated thyristor (IGCT) can not only 提高了动态恢复速度。给出了设计实例，并进行了仿真与实 manage the high power ratings, but also meet the requirements 验验证。 of grid fault ride-through and reactive power exchange, so it becomes the best choice for high power wind turbines. The 关键词：集成门极换流晶闸管；箝位电路；吸收电路；最小 optimal design of the clamping circuit is an important part of 脉宽；IGCT 变流器 the design of IGCT converters, which will highly impact on the 0 引言 SOA, minimum pulse width and grid current quality. A novel design method of the clamping circuit in IGCT converters was 门极换流晶闸管(gate commutated thyristor ， proposed in this paper and the calculation process has been GCT)