播出与总控系统通路及信号测试祥解.ppt

* The eye display can be used to evaluate the performance of the system and typically types of problems can be isolated within the system. For instance when an overshoot or undershoot is present within the eye display. This indicates that there are mis-terminations within the signal path. What is happening is the high energy that is present within the serial digital signal is coming along the cable and a mis-termination will not absorb all the energy of the signal and some of the signal will be reflected back down the cable. The problem is that other signals are still coming down the cable and will add and subtract certain parts of the signal as the reflected signal cause disturbance to the sending signal. This signals will still be received correctly. Within HD system we need to ensure that correct terminations are used throughout the signal path to prevent these overshoot and undershoot conditions which narrow the eye threshold. * The eye display can be used to evaluate the performance of the system and typically types of problems can be isolated within the system. In this case there is unequal rise and fall time in the signal which shifts the 50% point of the signal and causes the cross-over to occur at a higher or lower transition. In this case the signal will still be receiver correctly. However it does impair the signal and can cause the signal to fail when it becomes more noisy or suffers from jitter. * The jitter within the WFM7120 uses the demodulation method. Which uses a highly stable clock to compare against the recovered signal. This allows the jitter of the signal to be related to video line and field rates and allow more easily determination of possible jitter problems within the system. Normally we expect the launch amplitude of the device to be less than 0.2U unit intervals. A unit interval is one over the clock period of the signal. So for SD-SDI 0.2UI is 740ps and in the case of HD-SDI 0.2UI is 135ps. * Let take a look at a simple case