结构专业毕业设计计算书要点.docVIP

毕业设计材料 专业班级 土木工程（结构）103班 姓 名 吴 涛 指导教师 周骥（副教授） 所在学院 城建学院　 2014年 5月 总 目 录 毕业设计书 任务书 开题报告 外文翻译 毕 业 设 计 书 题 目杭州钱江创业中心1号楼A区框架结构设计 杭州钱江创业中心1号楼A区框架结构设计 学院 专业 摘 要：A Frame Structure Design Of Hangzhou Qian Jiang Entrepreneurship Center 3 Floor Area Abstract: In hangzhou qianjiang entrepreneurship center 3 floor area A frame structure to select A framework, first calculate the beam size, then calculate line stiffness of beams, each layer are calculated by the height look-up table wind load translates into each node concentrated load. Through beam size, the floor roof frame node standard load according to the line of dead load distribution coefficient of stiffness, internal force, by means of quadratic assignment and draw frame edge bending moment, bending moment and the column in the beam and column in the cross of edge shear, according to the figure in front of the column, Liang Zhuzhong bending moment and shear force draw a table column axial force thus draw the dead load bending moment diagram. Calculation of floor live load, according to the load are obtained live load distribution coefficient of internal force, by means of quadratic assignment with live load and dead load calculation method of calculation, and it is concluded that the column axial force, draw the bending moment diagram. Use D value method to calculate the wind loads of beam bending shear, axial force, draw the wind load under the action of bending moment diagram. According to the most adverse internal force combination draw internal force combination of values, and then calculates beam reinforcement. According to internal force combination selection in front of the two groups of independent foundation under column. Key words: Secondary distribution method; Beam load; Internal force combination;D value method; reinforcemen 目 录 1． 1 1．1 1 1．1．1 1 1．1．2 1 1．1．3 1 1. 1. 4 基本条件 2 1．2 2 2． 4 2．1 4 2． 4 2． 4