全向天线衰减器安装手册.docVIP

全向天线加载衰减器安装手册 Attenuator Installation manual for omni directional antenna 设备Equipment 直角转接头Right angle connector Picture 1 图1 10DB衰减器 10DB attenuator Picture 2图2 安装步骤 Installation procedure （1）Pre-Installation 安装前 Picture 3图3 （2）准备一个直角转接头和10DB的衰减器，如图4所示按照下图并连接好转接头和衰减器。 （使用1.6NM的扭距）Prepare one connectors and one attenuator，And connect them as following pic4.(with 1.6 NM) Picture 4 图4 （3）取下全向天线 Remove the antenna （4）如图4，连接好全向天线和（衰减器＋转接头）（使用1.6NM的扭距） As Pic4，connect the antenna and (attenuator +connector) (with 1.6 NM) （5）如图4，把（转接头＋衰减器＋全向天线）连接到TGC/TGCC上（使用使用1.6NM的扭距）,并使天线与波导管轴垂直。 As Pic4，connect (antenna +attenuator +connector) to TCG/TGCC (with 1.6 NM)。And omnidirectional antenna has to remain horizontally at 90 from waveguide axis (due to horizontal polarization requirement) 安装后检查 Installation checking 安装结束后，请立即检查。Pls. check the following before installation is finished. （1） 确保直角转接头、衰减器、天线之间拧紧（(1.6 NM的扭距)）。 Make sure the torque wrench is respected among connector, attenuator and antenna. （2） 确保天线的轴与波导管的轴垂直。 Make sure the antenna remain horizontally at 90 from waveguide axis （3） 确保天线、直接转接头、衰减器在列车的限界之外. Make sure attenuator + right angle + omni directional antenna is located outside train dynamic range. 衰减器attenuator 直角转接头 Right angle connector