汽车防撞报警系统(毕业设计)剖析.docVIP

本科毕业设计 题　　目 汽车防撞警报系统的设计 学生姓名　 专业名称　 通信工程 指导教师　 2015 年 5 月 8 日  汽车防撞警报系统的设计 摘要：汽车工业和电子工业并称为两大巨头的工业部门，与汽车和电子产业的发展和进步，现代汽车，越来越多的多用途电子技术，越来越多的汽车电子。运输业现在向高密度的方向的发展，电子控制技术进一步在交通安全和车辆导航应用。 本设计是基于单片机的汽车碰撞预警系统的设计核心，结合我国公路情况，司机的现有习惯和传感器技术，设计了汽车防撞预警系统，符合中国国情，其目的是：在紧急情况下，赶紧回到车上的微处理系统，通过微处理系统的操作，比较，然后作出判断，如果达到危险距离，激活的报警。该系统的研究过程中，根据不同的交通状况，从报警距离报警深入研究模拟选择应用电路电源设计信息的收集,和其他报警信号输出设备;与MCS - 51汇编语言开发了一个控制系统程序;最后,为了确保传感器的可靠性和稳定性,使用对应的干扰措施。障碍实现距离测试,显示和报警,超声波测距范围3厘米- 400厘米,Design of vehicle?collision warning?system ABSTRACT：Automobile industry and electronic industry and referred to as the industrial sector, the giants in the car and the development and progress of the electronics industry, modern cars, more and more multi-purpose electronic technology, more and more automotive electronics. Now towards the direction of the high density of transportation development, electronic control technology further application in traffic safety and vehicle navigation. This design is the design of the vehicle collision warning system based on MCU core, combining with the situation of highway in China, the driver of the existing habits and sensor technology, designs the automobile anti-collision warning system, conforms to Chinas national conditions, the aim is to: in case of an emergency, to remind the driver, the driver has certain pretreatment time, thus avoiding for driver negligence, fault judgment, fatigue and other reasons caused by the traffic accident, to ensure the safety of the driver. Its basic idea is: use of ultrasonic accurately measure the distance with the obstacles ahead, quickly back to the bus microprocessor system, through the operation of the microprocessor system, comparison, and then make a judgment, if dangerous distance, activate the alarm. In the process of the research of the system, according to the different traffic conditions, from analog alar