毕业论文——真空镀膜机电气控制系统.doc

毕 业 设 计 题 目 真空镀膜机电气控制系统 学 院 专 业 班 级 学 生 学 号 20100321072 指导教师 二〇一四年月日 摘 要 本文所研究的真空镀膜机是一种蒸发式卷绕系统的镀膜机，主要应用于PET、OPP、BOPP等塑料薄膜上蒸镀金属膜,也可应用于生产镀铝、镀锌铝或镀银锌铝电容膜。其总体结构主要由真空系统、卷绕系统、蒸镀系统及电控系统组成，通过PLC来实现对真空系统的各种泵、阀门等开关量的控制，通过三菱触摸屏实现后台管理、各种工艺参数的设定及控制功能，自动化程度较高，有利于生产效率的提高。 该电气控制系统主控单元采用PLC的FX系列的通过设置对纸张力、电机速度、蒸发舟的状态和蒸发量等工艺要求参数的控制Abstract In this paper, Vacuum coating machine,which is developed by this paper is an evaporation-type winding coating machine, mainly used in PET, OPP, BOPP and other plastic film evaporated metallic film, also can be used in the production of aluminum, galvanized aluminum or silver plated zinc aluminum capacitor film. The composition of its overall structure is mainly composed of a vacuum system, winding system, evaporation system and electric control system; On the one hand,through the PLC to control pump of the vacuum system ,valve switch and so on,on the other hand, through Mitsubishi touch screen to conduct back-stage management and control and set all kinds of Process parameters, this will improve the degree of automation and Is conducive to the improvement of production efficiency. The electric control system of main control unit is controlled by Mitsubishi FX series ,through Mitsubishi touch screen to set and control evaporation process on paper tension, motor speed, evaporation boat required parameters, besides fault alarm, protection route function. By RS232/485 serial interface and A /D conversion module controller to achieve various parameters transmission, information processing, detection and control function. Firstly, the vacuum system for coating machine and the evaporation process are nalyzed in this paper; and the the winding system of roll and the roll tension control model is established, then finding out the relevant factors that affect tension, and adopt the fuzzy adaptive tuning PID control algori