窗体顶部whichattributeisusedbyabridgetomakeforwarding.docVIP

1 窗体顶部 Which attribute is used by a bridge to make forwarding decisions? source IP address source MAC address destination IP address destination MAC address Layer 4-7 protocol address 窗体底部 2 窗体顶部 What is the effect of adding additional hosts to a half-duplex Ethernet network? (Choose three.) collisions increase collisions decrease jam signals increase jam signals decrease throughput decreases throughput increases 窗体底部 3 窗体顶部 How does an Ethernet bridge handle an incoming frame? (Choose three.) The source MAC address and input interface pair are added to the bridging table. The destination MAC address and input interface pair are added to the bridging table. If no match to the destination MAC address is found in the bridging table, the frame is discarded. If no match to the destination MAC address is found in the bridging table, the frame is flooded out all other interfaces. If a match to the destination MAC address is found in the bridging table, the frame is forwarded out the associated interface. If a match to the source MAC address is found in the bridging table, the frame is forwarded to all ports. 窗体底部 4 窗体顶部 Which of the following is used to build a switching table? source IP addresses destination IP addresses destination MAC addresses source MAC addresses 窗体底部 5 窗体顶部 After a collision occurs on a half-duplex Ethernet network, how does a transmitting host proceed? (Choose two.) It does not stop transmitting. It listens to determine if the network is in use before attempting to retransmit. It resumes transmitting while the jam signal clears the wire. It resumes transmitting based on the NIC back-off algorithm. It will take priority and be the first host to transmit after the collision. 窗体底部 6 窗体顶部 Which statements describe asymmetric switching? (Choose three.) It uses data compression algorithms to manage higher bandwidth interfaces. It is often use