翻译文献 L2CAP FEATURES.docVIP

大连交通大学2016届本科生毕业设计（论文）外文翻译 外文原文 LOGICAL LINK CONTROL AND ADAPTATION PROTOCOL SPECIFICATION 1 INTRODUCTION This section of the Bluetooth Specification defines the Logical Link Control and Adaptation Layer Protocol, referred to as L2CAP. L2CAP is layered over the Link Controller Protocol and resides in the data link layer as shown in Figure 1.1. L2CAP provides connection-oriented and connectionless data services to upper layer protocols with protocol multiplexing capability, segmentation and reassembly operation, and group abstractions. L2CAP permits higher level protocols and applications to transmit and receive upper layer data packets (L2CAP Service Data Units, SDU) up to 64 kilobytes in length. L2CAP also permits per-channel flow control and retransmission via the Flow Control and Retransmission Modes. Figure 1.1: L2CAP within protocol layers The L2CAP layer provides logical channels, named L2CAP channels, which are mapped to L2CAP logical links supported by an ACL logical transport, see baseband specification [vol.2, part B] Section 4.4 on page 86. 1.1 L2CAP FEATURES The functional requirements for L2CAP include protocol/channel multiplexing, segmentation and reassembly (SAR), per-channel flow control, error control and group management. Figure 1.2 on page 22 illustrates how L2CAP data flows fit into the Bluetooth Protocol Stack. L2CAP lies above the Link Controller Protocol and interfaces with other communication protocols such as the Bluetooth Service Discovery Protocol (SDP), RFCOMM, Telephony Control (TCS) and Bluetooth Network Encapsulation Protocol (BNEP). Voice-quality channels for audio and telephony applications and synchronous transparent connections are usually run over synchronous logical transports, see [vol.2, part B] Section 4.3 on page 86. Packetized audio data, such as IP Telephony, may be sent using communication protocols running over L2CAP. The L2CAP layer provides logical channels, named L2CAP channels, which are mapped to L2CAP logical lin