减速器参数表格.docVIP

B.4 Gear reducer data sheet 加速器数据表 Manufacturers are recommended to use this form below when providing gear reducer information. 在提供减速器信息的时候，推荐制造商采用如下的表格 Manufactured by制造商: Date submitted提交日期 Nominal reducer size额定减速器尺寸 Calculated Values 计算值 Pitting resistance torque抗孔蚀性扭 Units单位: Static torque矩静态扭矩 Units: First reduction一级减速 First reduction:一级减速 Second reduction二级减速 Gear大齿轮 Pinion小齿轮 Third reduction三级减速 Second reduction: 二级减速 Bending strength torque弯曲强度扭矩 Units: Gear Pinion First reduction一级减速: Third reduction:三级减速 Gear Pinion Gear Pinion Second reduction: Gear Pinion Third reduction: Gear Pinion Notes: 1. First reduction is high-speed reduction. 一级减速时高速减速 2. Second reduction is slow-speed reduction on double reduction gear reducers and the intermediate reduction on triple reduction gear reducers. 二级减速时双级减速器的低速和三级减速器的中级减速。 3. Third reduction is the slow-speed reduction on triple reduction reducers and is not applicable on double reduction reducers. 三级减速是指三级减速器的低速减速，不适用于双级减速。 Construction Features 结构数据 Type of reducer Cross out if not applicable 减速器的类型（不接受交叉式） Single 单级 Double 双级 Triple Reduction 三级 Single Double Helical gearing 螺线 Teeth齿轮齿 Number of teeth and normal diametral pitch or transverse diametral pitch: 齿轮齿数量和额定径节或是横向径节距 First reduction一级减速 Np Ng Pnd Pd Second reduction 二级减速Np Ng Pnd Pd Third reduction 三级减速Np Ng Pnd Pd Center distance and net face width:中心距和净面宽度 First reduction Cs, Wf Second reduction Cs, Wf Third reduction Cs, Wf Figure B.3 - Manufacturer’s gear reducer data sheet Helix angle and normal pressure angle or transverse pressure angle degrees : 螺旋角和常规压力角或横压力角（度） First reduction ψ, φn, φ t Second reduction ψ, φn, φ t Third reduction ψ, φn, φ t Geometry factors, I and J for pinion and gear 几何因数I和J 对于小齿轮和齿轮 First reduction geometry factor 一级减速几何因数I CJ,P CJ,G Second reduction geometry factor二级减速几何因数 I CJ,P CJ,G Third reduction geometry factor 三级减速几何因数I CJ,P CJ,G Manufacturing methods制造方法 Teeth generated by齿轮齿生产 process程序 Teeth f