10钢结构安装-2JHA.docVIP

JHA风 险 分 析 Company 公司: FCC上海赛科项目经理部 Job工作:苯乙烯钢结构施工 Installation for steel structure of Styrene Number 编号:设备-001 FCC Shanghai SECCO Project Management Department Date 日期:2003年10月5日 October 5,2003 Seq. No. Step of Task Chance of Loss Risk Ranking 风险评估值 Method of Control Residual Risk 序号 工作步骤 可能的危害或损失 S P R 对危害的控制方法 剩余危险 01 工机具的检查 Inspect equipments 电焊机等用电设备损坏造成漏电 Creepage resulted by damage of electric welding machine 2 1 2 作业前检查要使用的工机具是否完好，发现隐患应立即修理或更换 Check the equipments before work or repair or change hidden problems L 气割工具漏气造成烧伤 burn by leak from gas cut equipment 吊装索具、用具缺陷导致安全隐患 Hidden safety problem resulted by lifting rigging and equipment 吊车故障导致安全隐患 Hidden safety problem resulted by crane trouble 2 1 2 作业前检查气带胶管是否完好，发现有泄露立即修理 Check gas tube good or not before work and repair immediately the leak 吊装用索具符合国家有关规范要求，无打卷等情况 Lifting rigging comply with PRC requirements of relevant regulations as no rolling 所有吊车必须持有SECCO颁发的设备使用证，吊车的使用、拆除和移动符合使用说明书及操作规程的规定 All cranes should have passage for equipment of SECCO, use, removal and move should comply with regulations of specification and operation process 02 材料运输 Material transport 材料运输封车不牢，造成交通事故。 司机疲劳驾驶，引发事故 Traffic accident for materials not closed as well. Driver is tired to result accident. 2 1 2 材料运输严格检查封车情况 Strictly check the transportation vehicle for materials 禁止疲劳作业，每个司机连续驾车行驶时间不得超过8小时 No work as tired and driver should not work more than 8 continue hours L 码放过高倒塌造成人员伤害及材料损坏 Injury and damage of materials for too high materials 1 1 1 严格控制材料的码放高度 Control strictly height of material pile 03 吊装作业 Lifting work 支车不稳，造成翻车 Turn over for not support well 2 1 2 检查吊车站位位置及路基板铺设情况，检查吊车支车是否水平 Check stand position and roadbed plate for crane, and check the support vehicle for crane in level or not L 吊物滑落造成人员伤亡或损坏材料 Injury/death or damage materials for slip of lifting objects 3 1 3 确保提升前钢丝绳与吊物是否锁紧，吊装作业区域设置安全警戒线 Ensure the steel wire rope and lifting objects lock closed before lifting and set