各种灯头资料.pptVIP

* * CommonLight bulb bases Edison screw- E27, E14 The designation Exx of Edison Screw refers to the diameter in millimeters, e.g. E12 has a diameter of 12 mm. In the US the standard size is E26, although E12 is used for candelabra fixtures and E10 on some Christmas lights. E17 is also common, especially in some table lamps. In most countries which use 230-240 volts AC domestic power, E27 and E14 are common sizes. Larger sizes (E39, E40) are used for higher powered lighting, generally for lamps of over 250 watts. * * Edison screw- E27, E14 Edison Screw bases fittings table Source: Wikipedia (2008) * Source: Edison screw- E27, E14 Bayonet caps – B15, B22 Bayonet bases or caps are often abbreviated to BC, often with a number after. The number refers to the diameter of the base, e.g. BC22 is a 22 mm diameter bayonet cap lamp (B22d). BC15, a 15 mm base, can also be referred to as SBC standing for Small Bayonet Cap (B15d). * A set of bayonet mount Source: Wikipedia (2008) * Bayonet bases fittings table Source: Wikipedia (2008) Bayonet caps – B15, B22 GU5.3, GU10 Most common halogen spotlight are either push fit (GU4 or GU5.3), low voltage type or twist and lock (GU10 or GZ10) mains versions. There are subtle difference between GU10 and GZ10. The GU10 has a bevel around the base but the GZ10 has a square corner. This stops the GZ10 being used in a fitting designed for a GU10 but allows the GU10 to be used in either. * GU5.3 GU10 * Source: GU5.3, GU10 GU24 GU24 base sockets were designed to work with the new LVS (Line Voltage Socket) developed under the auspices of ENERGY STAR. That socket is only used for energy-efficient CFL bulbs * MR11, MR16 MR11 is a coded designation in which MR stands for Multifaceted Reflector and 11 is the number of eights of an inch the front is in diameter 11/8 or 34.9 mm. MR16 lamps are in diameter 16/8” or 50.8 mm. They usually have a 2 pin base, GU 5.3 (the fitting pins are 5.3mm apart), and runs on 12V, however the spotligh