双语课.docVIP

习题集 (Collection of Questions) Chapter 1 – Introduction to Polymeric Materials 1. Many polymers occur in nature. Name any two naturally occurring polymers. 2. What will happen when we begin heating each of the polymers below? a) A thermosetting (polymer). b) A thermoplastic (polymer). 3. Name any two properties that you may look for in describing a polymer. 4. Describe what is meant by the term polymer. 5. Briefly explain the difference in molecular chemistry between silicone polymer and other polymeric materials. Chapter 2桺hlastics 1. What is metallocene PE? And what are the differences among metallocene PE, HDPE and LLDPE? 2. How many types of conformations do the polypropylene have? 3. What are the main properties of PS? When compared with PS, what advantage does ABS have? 4. Define Polyvinyls, PS, PP, HDPE, chemical structure. 5. Compare the density PVC, PVB, PS, and PVDC which is higher/lower than PP. 6. Compare the density of HDPE, LDPE, UHMWPE, LLDPE to PP? 7. What is the tensile strength of PP with 0%, 30% glass fibers? What is the tensile modulus? 8. Plot tensile strength and tensile modulus of PVC, PS, PP, LDPE and HPDE to look like: 9. Which of the following are thermoplastics: hard rubber, Bakelite, PVC, polystyrene, polyethylene? 10. Which of the following are thermoset plastics: Melamine dishware, Bakelite, hard rubber? 11. What is the principal structural difference between LDPE and HDPE? 12. Which has the higher value for a specific polymer with both amorphous and crystalline regions: Tg or Tm? 13. Which is the faster reaction: step reaction or chain reaction polymerization? 14.? Write down the formulations of epoxy resin. 15.? List the main applications of epoxy plastics. 16.? What are the main processing methods of thermosetting plastics? 17.? Compared with thermoplastics, what are the advantage and disadvantage of thermosetting plastics? 18.? What are meant by A-stage and B-stage phenolics? 19.? What are the