路由器的综合实验(教育技术级研究生).docVIP

路由协议的综合实验报告 一、实验内容：在路由器上配置静态路由、RIP、和OSPF协议，实现互通。 二、实验目的：进一步深入理解路由协议的配置 三、实验拓扑图如下： 四、启动路由协议及配置各台路由器的信息如下： 路由器A的配置信息如下： [Quidway]sys RA [RA]inter s0 [RA-Serial0]ip add 1.1.1.1 255.0.0.0 [RA-Serial0]shutdown % Interface Serial0 is down [RA-Serial0] % Interface Serial0 changed state to DOWN [RA-Serial0]undo shutdown % Interface Serial0 is reset [RA-Serial0] % Interface Serial0 changed state to UP [RA-Serial0]quit [RA]ip route-static 0.0.0.0 0.0.0.0 1.1.1.2 [RA]disp ip rout Routing Tables: Destination/Mask Proto Pref Metric Nexthop Interface 0.0.0.0/0 Static 60 0 1.1.1.2 Serial0 1.0.0.0/8 Direct 0 0 1.1.1.2 Serial0 1.1.1.1/32 Direct 0 0 127.0.0.1 LoopBack0 1.1.1.2/32 Direct 0 0 1.1.1.2 Serial0 127.0.0.0/8 Direct 0 0 127.0.0.1 LoopBack0 127.0.0.1/32 Direct 0 0 127.0.0.1 LoopBack0 [RA]disp current-conf Now create configuration... Current configuration ! version 1.44 firewall enable sysname RA ! interface Ethernet0 ! interface Serial0 clock DTECLK1 link-protocol ppp ip address 1.1.1.1 255.0.0.0 ! interface Serial1 link-protocol ppp ! interface Serial2 flow-control none async mode protocol link-protocol ppp ! quit ip route-static 0.0.0.0 0.0.0.0 1.1.1.2 preference 60 return [RA]save Now writing the running config to flash memory. Please wait for a while...... write the running config to flash memory successfully 配置路由器B的信息如下： [Quidway]sys rb [rb]int s1 % Interface Serial1 changed state to UP [rb-Serial1]ip addr 1.1.1.2 8 [rb-Serial1]shut % Interface Serial1 is down [rb-Serial1] % Interface Serial1 changed state to DOWN [rb-Serial1]undo shu % Interface Serial1 is reset [rb-Serial1] % Interface Serial1 changed state to UP [rb-Serial1]quit [rb]int s0 [rb-Serial0]ip addr 2.2.2.