多轴和库.ppt

多轴铣削和库 多轴铣 例子 选择surface 驱动 选择如图驱动面，然后flip material 选择cut_direction 选择stepover 选择display drive path,如图 选择cutting 定义when gouging为retract 选择non-cutting-engage Status为manual 定义distance为1.5 Movement为linear 定义direction为tool axis 选择retract 然后ok Generate刀具轨迹 然后创建第二工序来加工叶片。选择可变轴 选择surface area驱动方法，选择如下面 Choose the Part icon and Select. Generate the tool path 拷贝并粘贴swarf操作 重新选择驱动面 阵列刀具轨迹 SWARF object and MB3 Object Transform. Choose Rotate About Line Choose Existing Line In the Operation Navigator, highlight the Program object and MB3 Generate 几种特殊的刀具轴方法 4-Axis Normal to Part 4-Axis Normal to Part defines a tool axis that uses a rotation angle and a rotation axis. The rotation angle allows the tool to rotate about the rotation axis while remaining normal to the axis. double-click on the VARIABLE_CONTOUR Set the Tool Axis option to 4-Axis Normal to Part under Tool Axis. Key in 15 in the Rotation Angle field. Set the Rotation Axis option to 2 Points Generate the tool path Reorient to a Front view Verify Change to a Right view Choose the Reverse Play icon 4-Axis Relative to Part double-click on the VARIABLE_CONTOUR object to edit the operation. change this to a 4-Axis Relative to Part tool axis. Key in 5.000 in the Lead field. Leave the Tilt set to 0.0000. Generate the tool path Reorient to a Front view Verify The rotation angle consistently remains 15 degrees to the right of the lead. The lead reverses 5 degrees to either side of the normal tool axis depending on the zig or zag cut direction Change to a Right view Choose the Reverse Play Interpolate Tool Axis In the Create Operation dialog, choose mill_multi-axis as the Type. Choose VARIABLE_CONTOUR as the subtype Set the Drive Method option to Surface Area Choose Select under Drive Geometry 选择第一张面 Choose Select Next Row 依次选完所有的面 Choose Display under Drive Geometry Choose Cut Direction Set the Stepover option to Scallop Key in 0.010 in the Scall