Chapter 4 Quality Inspection服装专业英语.ppt

ivanzxl@126.com * Uneven belt-loop size Missing belt-loop Pocket lining caught in bartacking Too short pocket bag Inseam skipped stitch Under layer exposed fullness Pocket setting misplaced Pocket edge not straight ivanzxl@126.com * Too much seam allowance in setting pocket Uneven size of back yoke Improper layer shown out Mismatched meet point of back yoke ivanzxl@126.com * Pocket-bag not extend to front fly Uneven tension at front fly top stitch Inseam grinning stitch Stud insecure Uneven front fly width ivanzxl@126.com * Front fly length too long Waistband twisted Wrong waistband height Stitch per inch less than specified Incorrect shape of back pocket Twisted bottom Stud misplace Exposed drill holes will be not closed ivanzxl@126.com * Uneven top-stitch at left fly Belt-loop not as sample Missing bartack Measurement out of tolerance Wrong care label The under crotch meet point not be matched ivanzxl@126.com * Zipper cannot reach at top Out-seam run off stitch Fraying the end of catching facing Fold fabric by improper bar-tack setting Uneven tension at pkt. top stitch ivanzxl@126.com * 4.4.5 Defect of shirt Collar edge asymmetric Uneven collar stand Collar tip grinning stitch Under layer exposed Collar bubbling due to uneven pressing Placket bubbling Uneven tension at top-stitch collar Twisted placket ivanzxl@126.com * Incorrect pocket size Uneven height in both side of cuff Defective buttons Collar size incorrect Seam broken of cuff edge Uneven of collar tip ivanzxl@126.com * Uneven length of front placket Pleated at sleeve joining Improperly pressed Collar tip seam broken Wrong edge margin Woven label 1/2 or more Off center ivanzxl@126.com * Side edge of pkt. Exposed Beyond side edge of flap Thread impression fused into Collar Fullness on the under ply of the cuff Raw edge-safety stitch seam Vent bar-tack causing pleat ivanzxl@126.com * Pressed in pleats Uneven distance of slv. Pleat Cuff assembles to slv. Not closed Collar assemble to bo