《大学计算机》学大纲(08-09.1更新).docVIP

目 录 《大学计算机基础》课程教学大纲（非艺术类） 2 《大学计算机基础》课程教学大纲（艺术类） 7 《大学计算机基础》课程教学大纲（非艺术类） 课程名称（中文/英文）：大学计算机基础/Computer Basic of University 课程类别：自然科学基础 课程性质：必修课 适用专业：非艺术类(除计算机、网络专业) 学 时 数：48 其中：实验/上机学时：16 学 分 数：2.5 考核方式：考查 预修课程： 无 教学参考书：阎丕涛编. 大学计算机基础. 科学出版社. 大学计算机基础. 科学出版社 center pin checks and anchoring the inner cylinder. According to While coupling alignment should keep oil out of cavity and locate the rotor axis neck raised are within the prescribed limits, there should be no gaps, Horn, Horn and Horn 0.05mm feeler gauges fit into. Center coupling, condenser water filling and water-filled according to factory requirement. For coupling three supported rotor Center, the mouth under the coupling between the value should be as stipulated in the manufacturer, usually 0.15~0.25mm. In the case of coupling connection, if possible, lifting only one bearing end of the support bearing of the rotor, remove the bearing, fitted with special tiles and special lifting tools, disc rotors, check the journal flutter tile, should generally be less than 0.10MM. When the couplings and rotor comes when there is a conflict, the coupling Centre shall prevail. 6.4.5.2.2 shaft looking for: ... 6.4.5.3. Provisional bolt confirmed the positioning of the rotor size, as well as the coupling between the adjustment shim thickness accuracy, drawings to meet the technical requirements. Plane, cylindrical and clean the coupling bolt holes should be clean and without burrs, scrap iron and grease-free, relative position of the coupling according to the drawing requirements are. Coupling top screws, round distance apart, indicators to monitor movement of the aircraft, its value is allowed to pass the value axis moving, mounted adjustment pads, note pads installation direction guide pin coupling with process end closed. The back wheels slowly tightened, when 2mm or so, with standard white bars where two back wheel bolt