网上申请教师资证的步骤.doc

内蒙古师范大学应届师范类本科毕业生申报高级中学教师资格填报说明 阅读此说明前请先网认真阅读《关于为201届毕业生办理教师资格证的通知》。在准备网上申报前请先准备好电子登记照片电子照片必须是114156像素文件大小不得大于20Kjpg格式。 打开“中国教师资格网”页面左侧有个选项分别是“”、“”。点第二个“”。进入后左侧是“登录入口”。 如果已经注册过则在上面输入姓名、身份证号、密码等登录。如果没注册第一次登录请点“” 进入“申请人必读”和“网上申报协议”页面。认真阅读后点下方的“已阅读并完全同意”然后点“下一步”。 进入“选择资格种类和认定机构”页面。 资格种类根据通知要求选择正确种类。选择“” ；选择市，统一选“呼和浩特市”，认定机构统一选择“呼和浩特市教育局”，任教学科如实选择即可。点击“下一步”。 图9 6 . 点击“下一步”进入下一页面。 申报第七步填写申请资料：普通话水平选项，蒙语授课学生填免测；毕业时间统一选择2012年7月1日类别一研究生专业、类别二本科专业类别四中职专业点击专业名称或前面的小图标可以展开更具体的专业网上申报时上传的电子照片要求：宽114像素，高156像素，大小不超过20K，jpg格式。 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge bloc