饮用水管道安装业指导书.doc

` CSPC NANHAI PETROCHEMICALS PROJECT CSPC 南 海 石 化 项 目 Working Instruction?For Drinking Water GRP Pipelines Installation 饮用水GRP 管道安装作业指导书 Project Procedure: WI-8710-8100-2025 项目程序: WI-8710-8100-2025 SEPCO Electrical Power Construction Corporation 山东电力基本建设总公司 版次 日 期 出版原因 编写 校核 审查 批准 A 30 December 03 Issue For Review And Approval Liudongxian Tiandexun Zhaoxie Shideping B 4 January 04 Issue For Review And Approval Liudongxian Tiandexun Zhaoxie Shideping  目 录 contents 1.0 范围 scope 3 2.0 目的 purpose 3 3.0 职责 responsibility 3 4.0 概述 general description 3 5.0 编制依据 reference 4 6.0 施工工艺及要求 construction process and requirement 4 7.0 附图 attached drawing 23 8.0 工作安全分析（JSA） 23 范围 scope 本程序适用于南海石化项目汽电联产部分，饮用水GRP管道安装、检验和试验。 This procedure is applicable to the erection, inspection and test of drinking water GRP pipe in Nanhai Petrochemicals Steam Power Unit. 2.0 目的 purpose 本程序规范给饮用水管道的安装、检验和试验，规定了管道的安装工艺、顺序以及施工中应注意的事项。 This procedure defines the erection process, sequence and precautions for the erection, inspection and test of drinking water pipe. 3.0 职责responsibility 3.1 山东电建二公司负责饮用水玻璃钢管道的安装、检验和试验。 SEP2 is responsible for the erection, inspection and test of the drinking water GRP pipe. 3.2 山东电建一公司负责饮用水管道的管沟开挖和回填。 SEP1 is responsible for the ditch excavation and backfill of the drinking water pipe. 3.3 基建总公司负责接口协调和质量验收。 SEPCO is responsible for the interface coordination and quality inspection. 4.0 概述 general 4.1 饮用水管道采用纤维缠绕玻璃钢管，设计压力为1.2MPa，正常工作压力0.45MPa。 The drinking water pipes are fiber wrapped steel pipe. The design pressure is 1