视觉系统DSP10_en.doc

DSP1.0 User Manual V1.0  Table Content Chapter 1 Copyright 1:3 Chapter 2 Preface 2:4 Chapter 3 Installation 3:4 3.1 Introduction 3:4 3.2 Install MPC03 3:4 3.3 Install Software 3:6 Chapter 4 Advanced Configuration 4:10 4.1 Machine Configuration 4:10 4.2 Parameters Settings 4:14 4.3 Camera Configuration Settings 4:15 Chapter 5 Camera Setting 5:17 5.1 5:17 5.2 5:22 Chapter 6 Model Settings 6:23 6.1 Model Settings 6:23 Chapter 7 Output 7:28 7.1 Output Interface 7:28 7.2 Array Setting 7:29 7.3 Laser power control 7:29 7.4 Control Button 7:29 Chapter 8 Appendix 8:30 8.1 System Configuration 8:30 8.2 Correcting test image 8:31 Copyright The content of this manual has been carefully prepared and is believed to accurate, but no responsibility is assumed for inaccuracies. Step-Servo Co., Ltd. reserves the right to make changes without further notice to any products herein to improve reliability, function or design. Step-Servo Co., Ltd. does not assume any liability arising out of the application or use of any product or circuit described herein; neither does it convey any license under its patent rights of others. Step-Servo and Leetro?are trademark of Step-Servo Co., Ltd. Step-Servo Co., Ltd.’s general policy does not recommend the use of its products in life support or aircraft applications wherein a failure or malfunction of the product may directly threaten life or injury. Per Step-Servo Co., Ltd.’s terms and conditions of sales, the user of Step-Servo Co., Ltd. products in life support or aircraft applications assumes all risks of such use and indemnifies Step-Servo Co., Ltd. against all damages. Contact Step-Servo Co., Ltd. Building 8-B Dayi Zone of Incubating No.1 South 2nd Keyuan Rd. Chengdu 610041 CHINA Internet: Email: overseas@ Tel: +86 28FAX: +86 28 ?2005 by Step-Servo Co., Ltd. All Rights Reserved Preface Thank you for buying and using Step-Servo’s Leetro? motion control cards and software. This