第二章 螺纹答案.docVIP

第二章 螺纹联接习题 appearance of the weld appearance quality technical requirements of the project must not have a molten metal stream does not melt the base metal to weld, weld seam and heat-affected zone surface must not have cracks, pores, defects such as crater and ash, surface smoothing, weld and base metal should be evenly smooth transition. Width 2-3 mm from the edge of weld Groove. Surface reinforcement should be less than or equal to 1 + 0.2 times the slope edge width, and should not be greater than 4 mm. Depth of undercut should be less than or equal to 0.5 mm, total length of the welds on both sides undercut not exceed 10% of the weld length, and long continuous should not be greater than 100 mm. Wrong side should be less than or at 0.2T, and should not be greater than 2 mm (wall thickness mm t) incomplete or not allow 7.5 7.5.1 installation quality process standards of the electrical enclosure Cabinet surface is clean, neat, no significant phenomenon of convex, close to nature, close the door. 7.5.2 Cabinet Cabinet face paints no paint, returned to rusted, consistent color. 7.5.3 uniform indirect gap from top to bottom, slot width 1.5mm 7.5.4 adjacent Cabinet surface roughness is 0. 7.5.5 the cabinets firmly fixed, crafts beautiful. 7.5.6 Cabinet surface gauge, switch cabinet mark clear, neat, firm paste. 7.5.7 Terminal row of neat, is reliable, the appearance is clean and not damaged. 7.5.8 cables neat and clean, solid binding, binding process in appearance. 7.5.9 the first cable production firm, crafts beautiful, clear signage does not fade. 7.5.10 fireproof plugging tight, no cracks and pores. 7.6 7.6.1 of the standard electrical wiring quality technology cable a, the multi-core wire bunch arrangement should be parallel to each other, horizontal wire harness or wire should be perpendicular to the longitudinal multi-core wire bunch. The distance between the wire harness and wire harness symmetry, and a