chapter10helicalgears(斜齿圆柱齿轮）.pptVIP

Chapter 10 Helical gears 斜齿圆柱齿轮） 10－2 Force on helical gear teeth Left hand helix and right hand helix 左旋和右旋） Helical gear geometry and forces Force analysis of gear system A gear train is composed of four helical gears with the shaft axes in a single plane. The gears have a 20? normal pressure angle and a 15?helix angle and a normal module of mn 2mm .Gear 1is cut right-handed and has 16 teeth. The gears on shaft b have 56 and 27 teeth respectively.. Gear 4 has 60 teeth. The driver rotates at 970 rpm and transmits 5kW. a ? Calculate the center distance between shafts a,b and b,c. b ? Calculate the pitch diameter of each gear. C indicate the Wt 、Wr and Wx on each gear of shaft b. The figure shows a gear train composed of a pair of straight bevel gears and a pair of helical gears. Shaft a is the input shaft of the train and delivers 17kW at a speed of 720 rpm. The bevel gears have a module of 5mm and a face with of gear is 50mm. The helical gears have a normal module of 6mm. a If the thrust forces on shaft b counteract , Indicate the hand of the helical gears. b ?. Indicate the Wt 、Wr and Wx on each gear of shaft b. Example 10-1 　　A helical gear has a normal diametral pitch of 8, a normal pressure angle of 20o 32 teeth, a　face width of 3.00 in, and a helix angle of 15o. Compute the diametral pitch, the transverse　pressure angle, and the pitch diameter. If the gear is rotating at 650 rpm while transmitting　7.50 hp, compute the pitch line speed, the tangential force, the axial force, and the radial force. 10-3 stresses in helical gear teeth The bending stress: where Ko overload factor for bending strength Ks size factor for bending strength Km load distribution factor for bending strength KB rim thickness factor Kv dynamic factor for bending strength See bottom of page 399 10-4 pitting resistance for helical gear teeth The contact stress Where Cp elastically coefficient table 9-10 I geometry factor table 10-1 10-2 10-5 design