《遥感技术基础期末复习.docVIP

第一章 §1.1 概述 遥感的概念 遥感第章 电磁波与电磁波谱§2.2 地物的电磁波辐射 2.2.1 黑体辐射斯忒藩－玻耳兹曼公式 2.2.2 太阳辐射大气窗口遥感 列举出常见的五种投影类型的名称及特点。 列举出7种国家基本地形图的比例尺。 列举出多波段数字图像存储及分发的3种数据格式。 论述3S技术在测绘工程中的使用。 引起遥感图像变形的因素都有哪些？ 遥感图像几何校正的一般过程 遥感图像的判读与处理 列举遥感图像常用判读标志 简述常用的遥感影像目视解译方法并举例说明 3、比较最大似然法与最小距离法的特点。 4、监督分类的主要步骤 5、比较K均值法与ISODATA法的优缺点 6、写出ISODATA的中文全称和步骤。 7、比较监督分类与非监督分类的优缺点 8、分类后精度评价，采集样本的方式？ 9、计算：利用Kappa系数计算分类精度 10、直方图均衡化的处理过程，并通过实例进行分析 考察方式：分类后精度评价，采集样本的方式？ 采集样本的方式有三种类型： 来自监督分类的训练样区； 专门选定的试验场； 随机取样。 一般采用混淆矩阵来进行分类精度的评定。 混淆矩阵 分类精度 Kappa系数。 spacing of 100mm. C, line line line nearby. D, spare wire unified terminal strip Terminal (terminal strip at the top of the vertical, horizontal terminal strip from the harness to Terminal Pai end at the beginning), length to ensure as far as Terminal and set aside. After e, form a wire harness, cable, line. When the line should be in the core wire for better identification and marking on the cards will be prepared in advance, alternate core core content for the cable numbering. F, finish line, according to the corresponding terminal locations, wire one by one from the bunch out, pulling line, should be kept parallel to each other and more. Core dark as possible, determined in accordance with specific conditions, it is required that: neat, beautiful, shapely, pleasing to the eye. 7.6.2 wiring technology, out of the core wire according to Terminal position, cut off the excess, with wire stripping pliers or electrician knife stripped of insulation, so that connection. Stripping should not damage the copper core. B, core wire on the oxide and chip-insulated electricians knife scrape. C, core processing has been completed, thread round long nose pliers in a clockwise direction. Circle with the screw in the direction of spin in the same direction, circle should be appropriate, it is best to slightly larger than the screws, bent round the circle and the length of root and appropriate so set screw is screwed on tight. D, when on the crimp-type terminals when wiring