基于单片机的家庭智能浇花器设计毕业设计.docVIP

  • 57
  • 0
  • 约1.45万字
  • 约 28页
  • 2016-10-18 发布于辽宁
  • 举报

基于单片机的家庭智能浇花器设计毕业设计.doc

毕业论文(设计) ??????????????????? 二Ο一四年 5 月 15 日 诚?信?声?明 论文中不包含其他人已经发表或撰写过的研究成果 ??????????????????毕业论文(设计)作者签名:?? ? 2014年 5月15日 基于单片机的家庭智能浇花器设计 摘要:本次设计的盆花自动浇水系统包括土壤温湿度的检测与控制及报警两大部分。土壤温湿度的检测与控制部分又包括了土壤温湿度的检测和显示、自动浇水系统。土壤温湿度的检测和显示以温湿度传感器SHT-11为感应部件,将检测到的土壤温湿度值送入51单片机(STC12C5A60S2),再由其输出进行显示。自动浇水系统设计为智能浇水:智能浇水部分是通过单片机程序设定浇水的上下限值与SHT-11送入单片机的土壤湿度值相比较,当低于下限值时,蜂鸣器就先报警,接着单片机就输出一个信号控制电磁阀打开,开始浇水,高于上限值时再由单片机输出一个信号控制电磁阀关闭,停止浇水。 关键词:89C51单片机 SHT-11温湿度传感器 C51程序 数字电路 基于单片机的家庭智能浇花器设计 Abstract: potted plant automatic watering system this design including soil temperature and humidity in the detection and control and alarm of two parts. Detection and control of part of the soil temperature and humidity and the soil temperature and humidity detection and display, automatic watering system. Soil temperature and humidity in the detection and display of temperature and humidity sensor SHT-11 as the sensing component, soil temperature and humidity will detect the value into the 51 micro controller(STC12C5A60S2), then the output to the display. Automatic watering system design for intelligent watering: intelligent watering part is compared to soil moisture by SCM procedures set watering of the upper and lower limits and SHT-11 into the single value, when the temperature is lower than the lower limit value, the buzzer will alarm, then the single-chip microcomputer can output a signal to control the electromagnetic valve is opened, the beginning of watering, higher than the limit value by the the single chip outputs a signal to control the electromagnetic valve is closed, stop watering. Keywords: 89C51 micro controller SHT-11 temperature and humidity sensor C51 procedures of digital circuit 基于单片机的家庭智能浇花器设计 摘要 3 基于单片机的家庭智能浇花器设计 Abstract 4 第一章 绪论 1 1.1 选题的目的和意义 1 1.2 毕业设计所采用的研究方法和手段 1 1.3 智能浇花 2 1.4本设计采用的方案和优势 2 第二章 硬件电路的设计 3 2.1电路图及简要说明: 3 2.1.1 控制电路 3 2.1.2 显示电路 4 2.1.3 外部按键中断 4 2.1.4 备用测量模块 5 第

文档评论(0)

1亿VIP精品文档

相关文档