第三章 运行和配置Cisco IOS.pptVIP

参考网站： 资料查询网站： 网络中IP地址查询网站： 网 址： webmaster@ 地址：安徽省合肥市长江西路816号 3.3 配置交换机 配置模式: 全局配置模式 wg_sw_a#configure terminal wg_sw_a(config)# 接口配置模式 wg_sw_a(config)#interface e0/1 wg_sw_a(config-if)# 3.3.1 配置交换机的主机名 3.3.2 配置交换机的IP地址 wg_sw_a(config)#ip address {ip address} {mask} 例如： wg_sw_a(config)#ip address 1 3.3.3 配置交换机的缺省网关 wg_sw_a(config)#ip default-gateway {ip address} 例如： wg_sw_a(config)#ip default-gateway 3.3.4 设定全双工/半双工选项 3.4 Cisco 路由器初始启动过程 3.4.1 系统配置对话 Router#setup --- System Configuration Dialog --- Continue with configuration dialog? [yes/no]: y At any point you may enter a question mark ? for help. Use ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets []. Basic management setup configures only enough connectivity for management of the system, extended setup will ask you to configure each interface on the system Would you like to enter basic management setup? [yes/no]: n 设置全局参数 Configuring global parameters: Enter host name [Router]:wg_ro_c The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration. Enter enable secret: cisco The enable password is used when you do not specify an enable secret password, with some older software versions, and some boot images. Enter enable password: sanfran The virtual terminal password is used to protect access to the router over a network interface. Enter virtual terminal password: sanjose Configure SNMP Network Management? [no]: 设置全局参数（续） Configure LAT? [yes]: n Configure AppleTalk? [no]: Configure DECnet? [no]: Configure IP? [yes]: Configure IGRP routing? [yes]: n Configure RIP routing? [no]: Configure CLNS? [no]: Configure IPX? [no]: Configure Vines? [no]: Configure XNS? [no]: Configure Apollo? [no]: 初始的协议设置 设置端口参数 BRI interface needs isdn switch-type to be configu