不同胶粘剂的选用对生物质风力发电机叶片阻燃性能的-国际竹藤中心.docVIP

不同胶粘剂的选用对生物质风力发电机叶片阻燃性能的影响 孙正军 黄晓东 江泽慧 （国际竹藤网络中心， 北京 100102）2分钟内kw.min/m2）, 5分钟内kw.min/m2）；环氧树脂作为竹增强复合材料的胶粘剂的阻燃效果最好，其在HRR3热释放率系统测试中，着火燃烧时间最长（47秒），达最高热释放率时间最长（228秒），热释放率峰值最低（69.27kw/m2），氧指数值最高（55）, 2分钟内kw.min/m2）, 其在分钟内kw.min/m2）。FAA），HRR3热释放率系统 The Effect of Apply of the Different Adhesive on the Flame-Retardant Properties of Wind Turbine Bio-Blades Composite materials SUN Zheng-jun Huang Xiaodong JIANG Ze-hui Research Institute of International Center for Bamboo and Rattan ，Bei jing 100102, China Abstract: The wind turbines usually fixed on remote island, high mountain, and desert area. The turbine blades were easy burn down due to suffer to high temperament, lightning, fire .For this reason, the flame-retardant properties of the material selection of the wind turbine blades plays an important role in the wind turbine designs. In this study the flame-retardant properties of Heat Release Rate HRR and the oxygen index value of the bamboo strengthen composite material samples made from urea-formaldehyde resin, phenol-formaldehyde resin PF , phenol -formaldehyde and epoxy resin m（PF）/m（epoxy resin） 7:3 , epoxy resin was tested by HRR3 Heat Release Rate System equipment and HC–2 oxygen index equipment. The results showed that: The inferior flame-retardant properties appeared when the bamboo strengthen composite material samples made from urea-formaldehyde resin UF in this HRR3 study, the time that samples begin to ignite is the shortest 42s , the time that samples reach the highest Heat Release Rate is the shortest 95s , the peak that projects reach the Heat Release Rate is the highest 120.73kw/m2 , the mount that projects reach the oxygen index value is the lowest 38 , total Heat Release amount in 2 minute is the highest（97.12kw.min/m2）and total Heat Release amount in 5 minute is the highest（385.07kw.min/m2）；The best flame-retardant properties appeared when the bamboo strengthen composite material samples made from epoxy resin in this HRR3 study,