智能水表的设计与实现(45页).doc

摘 要 长期以来，自来水用户的用水量管理依靠人工抄表，由收费员到各家收费或各用户去银行交费。这种传统收取水费的做法需要的工作人员多，费时、费力、效率低，且常常出现用户欠费、迟缴或漏缴水费等问题，这自来水公司和用户都带来很多的不方便与矛盾。基于单片机的IC智能水表不但可以提高供水部门的工作效率，而且在技术上为节约用水、合理用水创造了条件由于这些特点，基于单片机的IC智能水表得到了越来越广泛的应用。 本论文主要设计基于单片机的IC卡智能水表电路。系统包括以下几个功能模块：供电电源、流量传感器、IC卡读/写器、LCD显示模块主控芯片选用单片机AT89S51。 智能水表作为一种顺应自来水行业发展需要的产品，它的出现极大的改善了传统管理模式下存在的抄表难、收费难等问题，改变了现有的用水机制，增强了人们的节水意识，实现了供水管理部门高效管理自动化。 关键词：智能IC卡，读卡器，AT89S51，LCD ABSTRACT For a long time, the administration of the tap water scalar for the users has been relied on the copy of the water meter. With this method the toll collectors should drop in for the charge or the users consign to the bank themselves. This traditional method of the tap water charge needs a lot of workers. What’s more, the efficiency of this way is very low and it often engenders arrearage and evasion of the charge, which causes incovenience and conflict to both the users and the waterworks. The application of intelligent water meter not only improves work efficiency of the department supplying water, and realizes using water electronically but also creates a condition for using water frugally and rationally. Because of these characteristics, intelligent water meter obtained more and more widespread application. In this paper, the main design based on single-chip pre-charges the IC card water meter system hardware circuit design. The system concludes the following functional modules: power supply, flux sensor、IC card reader、LCD show module 、larm circuit、amper circuit, and the microcontroller AT89S51 as its master CMOS chip. As the product to conform the development of the tap water industry, intelligent water meter greatly decrease the difficulty in charge and the copy of the water meter. What’s more, it can change the current water mechanism, enhance the sense of saving water, and realize the automation in the water supply department’s management. KEYWORDS: intelligent IC card, card reader, AT89S51, LCD 目 录 前 言 1 第1章 绪论 5 1.1 传统水表 5 1.1.1 传统水表的主要结构 5 1.1.2 传统水表